Enhanced heat transfer in 3D printed ball-end grinding tool with blade-shaped structure
Authors:
- Mingcong LiMLMingcong Li
- Yun HuangYHYun Huang
- Wenxi WangWWWenxi Wang
- Heng LiHLHeng Li
- Shengbo YanSYShengbo Yan
- Lai ZouLZLai Zou
- 17 February 2024
- journal article
- research article
- Published by Elsevier in Applied Thermal Engineering
- Vol. 244
Abstract
No abstract availableKeywords
Funding Information
- Fundamental Research Funds for the Central Universities (2023CDJXY-024)
- National Natural Science Foundation of China (52105430)
- China Postdoctoral Science Foundation (2023M740398)
This publication has 32 references indexed in Scilit:
- Experimental investigation of thermal performance of the oscillating heat pipe for the grinding wheelInternational Journal of Heat and Mass Transfer, 2019
- The effect of the entrance hub geometry on the efficiency in an axial flow fanInternational Journal of Refrigeration, 2019
- Energy saving with using of elliptic pillows in turbulent flow of two-phase water-silver nanofluid in a spiral heat exchangerInternational Journal of Numerical Methods for Heat & Fluid Flow, 2019
- Trajectory planning of abrasive belt grinding for aero-engine blade profileThe International Journal of Advanced Manufacturing Technology, 2019
- Cooling capability of liquid nitrogen and carbon dioxide in cryogenic millingCIRP Annals, 2019
- CFD analyses of a radial fan for electric motor coolingThermal Science and Engineering Progress, 2018
- Investigating the effect of nanoparticles diameter on turbulent flow and heat transfer properties of non-Newtonian carboxymethyl cellulose/CuO fluid in a microtubeInternational Journal of Numerical Methods for Heat & Fluid Flow, 2018
- Some critical issues in cryo-grinding by a vitrified bonded alumina wheel using liquid nitrogen jetJournal of Materials Processing Technology, 2016
- On the design and structural analysis of jet engine fan blade structuresProgress in Aerospace Sciences, 2013
- Wheel curve generation error of aspheric microgrinding in parallel grinding methodInternational Journal of Machine Tools and Manufacture, 2006