Braced Excavations: Temperature, Elastic Modulus, and Strut Loads
Authors:
- 1 October 2000
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 126 (10) , 870-881
Abstract
Relationships between strut loads, earth pressures, temperatures, and the measurements provided by strain gauges are presented in this paper. A braced excavation up to 20-m deep, 9–20 m wide, and >650-m long constructed in competent glacially derived sand, silt, and clay soils (including glacial till) provided a significant amount of data for analysis. The excavation was supported by soldier piles and lagging with pipe struts and was covered with decking during construction. A direct correlation between incremental changes in strut load and temperature was observed during the course of the project. The few existing relationships between strut load and temperature were reexamined and were found to produce back-calculated elastic modulus values that were either without comparison or inconsistent with data from field tests and published sources. The relationships derived as a result of this work are supported by limited case-history data from other published sources and are consistent with practical application of elastic deformation concepts and published soil modulus values.Keywords
This publication has 6 references indexed in Scilit:
- Comparative evaluation of building responses to an adjacent braced excavationCanadian Geotechnical Journal, 1999
- Measurement of Strut Loads by Means of Vibrating-Wire Strain Gages1975
- Closure to “Settlement of Spread Footings on Sand”Journal of the Soil Mechanics and Foundations Division, 1970
- Settlement of Spread Footings on SandJournal of the Soil Mechanics and Foundations Division, 1968
- Further notes on the Demec, a demountable mechanical strain gauge for concrete structuresMagazine of Concrete Research, 1955
- Theoretical Soil Mechanics1943