Influence of buccal bony crest width on marginal dimensions of peri‐implant hard and soft tissues after implant installation. An experimental study in dogs

Authors:

Abstract
Aim: To evaluate the influence of the width of the buccal bony wall on hard and soft tissue dimensions following implant installation.Material and methods: Mandibular premolars and first molars of six Labrador dogs were extracted bilaterally. After 3 months of healing, two recipient sites, one on each side of the mandible, were prepared in such a way as to obtain a buccal bony ridge width of about 2 mm in the right (control) and 1 mm in the left sides (test), respectively. Implants were installed with the coronal margin flush with the buccal alveolar bony crest. Abutments were placed and the flaps were sutured to allow a non‐submerged healing. After 3 months, the animals were euthanized and ground sections obtained.Results: All implants were completely osseointegrated. In respect to the coronal rough margin of the implant, the most coronal bone‐to‐implant contact was apically located 1.04 ± 0.91 and 0.94 ± 0.87 mm at the test and control sites, respectively, whereas the top of the bony crest was located 0.30 ± 0.40 mm at the test and 0.57 ± 0.49 mm at the control sites. No statistically significant differences were found. A larger horizontal bone resorption, however, evaluated 1 mm apically to the rough margin, was found at the control (1.1 ± 0.7 mm) compared to the test (0.3 ± 0.3 mm) sites, the difference being statistically significant.A thin peri‐implant mucosa (2.4–2.6 mm) was found at implant installation while, after 3 months of healing, a biological width of 3.90–4.40 mm was observed with no statistically significant differences between control and test sites.Conclusions: A width of the buccal bony wall of 1or 2 mm at implant sites yielded similar results after 3 months of healing in relation of hard tissue and soft tissues dimensions after implant installation.

This publication has 21 references indexed in Scilit: