Selective separation and preconcentration studies of chromium(VI) with Alamine 336 supported liquid membrane
- 1 April 2006
- journal article
- research article
- Published by Taylor & Francis in Toxicological & Environmental Chemistry
- Vol. 88 (2) , 187-196
Abstract
Chromium compounds have received considerable attention because these are used extensively in such industrial applications as electroplating, steelmaking, tanning of leather goods, and corrosion inhibition. The use of supported liquid membranes (SLMs) to remove metals from wastewaters has actively been pursued by the scientific and industrial community. In the present work, the selective separation and preconcentration of Cr(VI) ions has been studied by using a commercial amine as the membrane liquid on the porous polypropylene support. Permeation experiments were conducted on a laboratory scale batch reactor made up of perspex, with a memberane fixed amid the two chambers. The flux of Cr(VI) ions was found to be maximum (3.15 × 10−5 mol cm−2 s−1) around pH 1. Above and below this pH the flux decreases. Distribution studies show that an increase in the amine concentration leads to higher distribution coefficients at fixed pH values. At pH around unity, the distribution of Cr(VI) ions into the organic phase was found to be maximum, of the order of 56.3. The Cr(VI) transport through the membrane increases with rise in temperature. In order to check the long-term efficiency of the flat sheet SLM, an experiment was conducted with higher Cr(VI) concentration (5000 ppm) for 24 h, at optimised parameters. It was observed that in 24 h, about 1/5th of the feed Cr(VI) is left over while the rest is transported. However, minute organic droplets were also seen in the feed and strip compartments, after 1 day. This observation suggested the loss of membrane liquid. The feasibility of preconcentration of Cr(VI) by using the proposed SLM parameters, was also studied by using the hollow fibre (HF) system. Highest enrichment factor (E.F) value was obtained for 50 mg L−1 whereby all of the metal was transported to the stripping phase and the resulting Cr concentration was 688 mg L−1 (E.F = 13.8). It was observed that while treating more diluted solutions, the enrichment factor decreases. The values of E.F equal to 8.9 and 11.3 were found for initial Cr concentration of 10 and 30 mg L−1.Keywords
This publication has 19 references indexed in Scilit:
- Applicability of liquid membranes in chromium(VI) transport with amines as ion carriersJournal of Membrane Science, 2005
- Selective recovery and preconcentration of mercury with a benzoylthiourea-solid supported liquid membrane systemAnalytica Chimica Acta, 2005
- The role of some compounds on extraction of chromium(VI) by amine extractantsJournal of Hazardous Materials, 2005
- Hollow fiber based supported liquid membrane: a novel analytical system for trace metal analysisAnalytica Chimica Acta, 1997
- Modelling and simulation of integrated membrane processes for recovery of Cr(VI) with Aliquat 336Journal of Membrane Science, 1996
- Recovery of chromium from tannery effluents using a redox–adsorption approachJournal of Chemical Technology & Biotechnology, 1995
- Application of supported liquid membranes for removal of nitrate, technetium (VII) and chromium (VI) from groundwaterJournal of Membrane Science, 1991
- Development of a Spiral-Type Flowing Liquid Membrane Module with High Stability and Its Application to the Recovery of Chromium and ZincSeparation Science and Technology, 1989
- Uranyi ion transport through tri-n-octylamine-xylene based supported liquid membranesJournal of Radioanalytical and Nuclear Chemistry, 1987
- Extraction of chromium and zinc from cooling tower blowdown by liquid membranesJournal of Membrane Science, 1984