Assessing the Technical Specifications of Predictive Maintenance: A Case Study of Centrifugal Compressor
Open Access
- 8 February 2021
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 11 (4) , 1527
Abstract
Dependability analyses in the design phase are common in IEC 60300 standards to assess the reliability, risk, maintainability, and maintenance supportability of specific physical assets. Reliability and risk assessment uses well-known methods such as failure modes, effects, and criticality analysis (FMECA), fault tree analysis (FTA), and event tree analysis (ETA)to identify critical components and failure modes based on failure rate, severity, and detectability. Monitoring technology has evolved over time, and a new method of failure mode and symptom analysis (FMSA) was introduced in ISO 13379-1 to identify the critical symptoms and descriptors of failure mechanisms. FMSA is used to estimate monitoring priority, and this helps to determine the critical monitoring specifications. However, FMSA cannot determine the effectiveness of technical specifications that are essential for predictive maintenance, such as detection techniques (capability and coverage), diagnosis (fault type, location, and severity), or prognosis (precision and predictive horizon). The paper proposes a novel predictive maintenance (PdM) assessment matrix to overcome these problems, which is tested using a case study of a centrifugal compressor and validated using empirical data provided by the case study company. The paper also demonstrates the possible enhancements introduced by Industry 4.0 technologies.Keywords
Funding Information
- Universitetet i Stavanger (IN-11626)
This publication has 55 references indexed in Scilit:
- Vibrations supervision in gas turbine based on parity space approach to increasing efficiencyJournal of Vibration and Control, 2013
- Prediction of impeller rotating stall onset using numerical simulations of a centrifugal compressor. Part 2: Evaluation of mass-flow fluctuations at rotor–stator interfacesProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2013
- Fuzzy logic approach applied to the surge detection and isolation in centrifugal compressorAutomatic Control and Computer Sciences, 2010
- Empirical mode decomposition, an adaptive approach for interpreting shaft vibratory signals of large rotating machineryJournal of Sound and Vibration, 2009
- Experiments and modelling of surge in small centrifugal compressor for automotive enginesExperimental Thermal and Fluid Science, 2008
- PoD curves, their derivation, applications and limitationsInsight - Non-Destructive Testing and Condition Monitoring, 2007
- Simulation of Compressor Transient Behavior Through Recurrent Neural Network ModelsJournal of Turbomachinery, 2005
- Development and Experimental Validation of a Compressor Dynamic ModelJournal of Turbomachinery, 2004
- Towards a Methodology for Developing Evidence‐Informed Management Knowledge by Means of Systematic ReviewBritish Journal of Management, 2003
- Classification of radial compressor faults using pattern-recognition techniquesControl Engineering Practice, 1998