Lattice strain and static disorder determination in heterostructures by convergent beam electron diffraction
- 15 November 1999
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review B
- Vol. 60 (19) , 13750-13761
Abstract
Lattice strain and static disorder present in alloys forming heterostructures with a Ge atomic fraction x equal to 0.1, 0.2, and 0.3, have been studied by convergent beam electron diffraction and large-angle convergent beam electron diffraction. These techniques have been used in order to perform structural analysis of the alloys with a spatial resolution comparable with the dimensions involved in Si/SiGe applications. Strain values along directions both perpendicular and parallel to the sample surface have been determined from a single high-order Laue zone deficiency lines pattern. The resulting relaxed alloy lattice constant has been found to depend on the Ge atomic fraction following a nearest-neighbor model alloy, where the Si-Si, Ge-Ge, and Si-Ge bond lengths combine themselves with a negligible dependence on the Ge atomic fraction. From lattice strain values, both the strain-induced bond bend in the plane of the interface, and the strain-induced bond stretch have been determined. Static disorder measurements, performed by comparing the integrated intensity of high-angle diffracted beams in the silicon substrate and in the SiGe layers, allow the determination of the atomic mean-square displacements produced by the presence in the same coordination shell of Si-Si, Ge-Ge, and Si-Ge atomic pairs with different bond lengths. The measured atomic displacements are greater than the ones predicted by both the nearest-neighbor solution model (which only accounts for the different bond lengths, and not for both bond bend and strain) and a relaxed alloys structure Monte Carlo simulation (which accounts for differences in bond lengths and bond bend, but neglects the effect of strain). The component of the atomic displacement related to the macroscopic strain has been determined as the difference between the experimental values and those computed by Monte Carlo code. A linear correlation between the strain-induced atomic displacement and the strain-induced bond bend in the plane of the interface has been found.
Keywords
This publication has 24 references indexed in Scilit:
- Static Disorder Depth Profile in Ion Implanted Materials by Means of Large Angle Convergent Beam Electron DiffractionPhysical Review Letters, 1998
- Determination of bulk mismatch values in trasmission electron microscopy cross-sections of heteostructures by convergent-beam electron diffractionPhilosophical Magazine A, 1998
- Strain relaxation and dislocations in SiGe/Si structuresMaterials Science and Engineering: R: Reports, 1996
- Analysis of thin-film solid solutions on single-crystal silicon by simulation of x-ray rocking curves: B-Si and Ge-Si binary alloysJournal of Applied Physics, 1993
- Automated lattice parameter measurement from HOLZ lines and their use for the measurement of oxygen content in YBa2Cu3O7-δ from nanometer-sized regionUltramicroscopy, 1992
- Lattice parameters and local atomic structure of silicon-rich Si-Ge/Si (100) filmsPhysical Review B, 1991
- The effects of elastic relaxation on transmission electron microscopy studies of thinned composition-modulated materialsJournal of Vacuum Science & Technology B, 1986
- Higher order Laue zone effects in electron diffraction and their use in lattice parameter determinationProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1977
- Bloch waves and higher order Laue zone effects in high energy electron diffractionProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1976
- Lattice Parameter and Density in Germanium-Silicon Alloys1The Journal of Physical Chemistry, 1964