Toward the Improvement of the Short‐Loop Recycling of Dy‐Rich Nd–Fe–B Permanent Magnets: Experimental and Numerical Approaches
Open Access
- 21 March 2024
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 26 (9)
Abstract
The method of short‐loop recycling of Nd–Fe–B magnets is implemented, with end‐of‐life (EoL) magnets used as a source of heavy rare earth (HRE). Partially recycled magnets are fabricated by co‐sintering HRE‐free powders obtained from strip casted alloys, blended with HRE‐rich powders obtained from EoL magnets. The impact of several process parameters (blending ratio, sintering cycle, and HRE‐rich recycled particle sizes) on the microstructure and magnetic properties is discussed. A coercivity gain up to 160 kA m−1 wt%−1 of Dy with respect to the HRE‐free magnets is reported, even though impurities are incorporated. Microstructural characterizations show a heterogeneous Dy localization in core–shell/anticore–shell structures, and thus a nonoptimal use of HRE. The experimental results are compared with finite element simulations of the Dy diffusion transport performed using existing data of bulk Dy diffusion coefficients. The simulation model consists of a network of square grains separated by a liquid phase, whose fraction is based on the ternary Nd–Fe–B phase diagram. Results show similarities with the observed microstructures, and point to the interest of reducing the Dy‐rich particle size with respect to the main powder. This study provides new insights into the Dy transport mechanisms at stake in an efficient short‐loop recycling of HRE.Keywords
Funding Information
- Commissariat à l'Énergie Atomique et aux Énergies Alternatives
- Bpifrance
This publication has 76 references indexed in Scilit:
- The role of anti-core–shell structure caused by over-saturation diffusion of heavy rare earths in Nd-Fe-B magnets: a micromagnetic simulation studyApplied Physics A, 2023
- Understanding the Role of Element Grain Boundary Diffusion Mechanism in Nd–Fe–B MagnetsAdvanced Functional Materials, 2021
- Upscaling the 2‐Powder Method for the Manufacturing of Heavy Rare‐Earth‐Lean Sintered didymium‐Based MagnetsAdvanced Engineering Materials, 2021
- Sintered Nd-Fe-B magnet with core–shell structures fabricated through the intergranular addition of ultra-fine as-disproportionated (Nd,Dy)–Fe–B–Cu powderJournal of Materials Science: Materials in Electronics, 2020
- Recycling of scrap sintered Nd–Fe–B magnets as anisotropic bonded magnets via hydrogen decrepitation processJournal of Material Cycles and Waste Management, 2014
- Recycling Used Nd‐Fe‐B Sintered Magnets via a Hydrogen‐Based Route to Produce Anisotropic, Resin Bonded MagnetsAdvanced Energy Materials, 2012
- Grain boundary wetting in the NdFeB-based hard magnetic alloysJournal of Materials Science, 2012
- Magnetic Materials and Devices for the 21st Century: Stronger, Lighter, and More Energy EfficientAdvanced Materials, 2010
- Review: liquid phase sinteringJournal of Materials Science, 2008
- Thermodynamic assessment of the Fe-Nd-B phase diagramJournal of Phase Equilibria and Diffusion, 1995