Comparison Between Different Design Topologies for Multi-Megawatt Direct Drive Wind Generators Using Improved Second Generation High Temperature Superconductors
Authors:
- 2 December 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 25 (3) , 1-5
Abstract
Various design topologies were investigated to study the weights and costs for a direct drive wind turbine generator using improved second generation (2G) YBCO high temperature superconductors (HTS). Five different design topologies using combinations of air core, iron core, salient and non-salient configurations for both stator and rotor were considered for a generator with the nominal rating of 10 MW, 8 RPM and 3300 V. The main objective of the investigation was to minimize the HTS quantities and the reduction of total cost to achieve the same rating performance. The electromagnetic design was performed using transient finite element modeling including the improved HTS conductor characteristic properties. The mechanical design includes the support structures for both full load operation and sudden three-phase terminal fault conditions which can cause severe stresses.Keywords
Funding Information
- ARPA-E (Advanced Research Projects Agency-Energy) of the U.S. Department of Energy (DE-AR0000196)
- “High Performance, Low Cost Superconducting Wires, and Coils for High Power Wind Generators.”
This publication has 12 references indexed in Scilit:
- Installation, Operation, and Maintenance Strategies to Reduce the Cost of Offshore Wind Energy2013
- Design and characteristic analysis of 10 MW class superconducting wind turbine generators with different types of stator and rotor configurations2013
- Design and Analysis of High Temperature Superconducting Generator for Offshore Wind TurbinesIEEE Transactions on Magnetics, 2013
- 2011 Cost of Wind Energy Review2013
- Enhanced critical currents in (Gd,Y)Ba2Cu3Oxsuperconducting tapes with high levels of Zr additionSuperconductor Science and Technology, 2013
- High power dense electric propulsion motors2013
- Electromagnetic design study of 10 MW-class wind turbine generators using circular superconducting field coils2011
- 10 MW Class Superconductor Wind Turbine GeneratorsIEEE Transactions on Applied Superconductivity, 2011
- Cost effective fully fed wind turbine HTS generator: An alternative to existing generators in offshore wind farms2011
- Second-Generation HTS Conductor Design and Engineering for Electrical Power ApplicationsIEEE Transactions on Applied Superconductivity, 2009