Mitigating the Anisotropy of the Microstructure and Mechanical Properties of L-PBF-Fabricated H13 Steel via Rare Earth Ce Addition
Open Access
Abstract
H13 tool steel is widely used in the hot work die industry owing to its excellent mechanical properties. However, the inherent anisotropy of its microstructural and mechanical properties during additive manufacturing (AM) via laser powder bed fusion (L-PBF) hinders its broader application. In the current study, Ce-containing and as-built samples were prepared in both vertical and horizontal directions, and their microstructures and tensile properties were investigated. Notably, the grain size of the vertical samples is approximately 2.7 μm, which is 19.2% smaller than that of the horizontal samples in L-PBF H13 steel. In addition, the retained austenite (RA) content in the vertical samples reaches as high as 19.7%, whereas in the horizontal samples, it is only 0.4%. After the addition of Ce, the columnar grains of the building direction (BD) samples transform into equiaxed grains. The RA content of the scanning direction (SD) samples and BD samples is 6.3% and 5.7%, respectively. The tensile test results further demonstrate that Ce-containing BD samples exhibit a tensile strength of 2025.3 MPa and an elongation of 17.3%, with the elongation difference between the two directions being only 0.2%. The addition of Ce reduces microstructural anisotropy, resulting in a significant decrease in the mechanical property anisotropy of the formed parts.Keywords
Funding Information
- National Natural Science Foundation of China (52434009)
- National Natural Science Foundation of China (52304357)
- Shaanxi Outstanding Youth Science Foundation (2024JC-JCQN-52)
- Young Elite Scientist Sponsorship Program by CAST (YESS20240807)
- Shaanxi Provincial Science and Technology Plan Project (2024QCY-KXJ-109)
- Xi’an Science and Technology Bureau Project (2022JH-GXQY-0010)
- Key Research and Development Project of Shaanxi Province (2024GX-YBXM-211)
- Xi’an Science and Technology Program Project (24GXFW0040)
This publication has 31 references indexed in Scilit:
- Optimizing microstructure and mechanical performance in LPBF-processed TiCN-AlZnMgCu composites: From composition to TPMS reinforcementJournal of Alloys and Compounds, 2025
- Electron beam melting of H13 hot-work steels: mechanical properties, microstructure evolution, precipitation behaviorJournal of Materials Research and Technology, 2025
- Forming process study of laser power bed fusion H13 steel by finite element simulation and experimentJournal of Iron and Steel Research International, 2025
- Enhanced red hardness through fine carbides in M2 high-speed steel fabricated via electron beam powder bed fusionJournal of Materials Research and Technology, 2025
- Anisotropy of microstructure, mechanical properties and thermal expansion in Invar 36 alloy fabricated via laser powder bed fusionAdditive Manufacturing, 2024
- Effect of lithium anti-ablation and grain refinement introduced by TiC nanoparticles in LPBF Al–Li alloyJournal of Materials Research and Technology, 2023
- Effect of heat treatment on microstructural evolution, mechanical properties and tribological properties of H13 steel prepared using selective laser meltingJournal of Iron and Steel Research International, 2023
- Effect of Cerium on the Behavior of Primary Carbides in Cast H13 SteelsMetallurgical and Materials Transactions B, 2021
- Effects of Ti and Al addition on the Formation and Evolution of Inclusions in Fe-17Cr-9Ni Austenite Stainless SteelMetallurgical and Materials Transactions B, 2020
- Microstructure and mechanical properties investigation of CP titanium processed by selective laser melting (SLM)Journal of Materials Processing Technology, 2017