SEBAL-A: A Remote Sensing ET Algorithm that Accounts for Advection with Limited Data. Part II: Test for Transferability
Open Access
- 10 November 2015
- journal article
- research article
- Published by MDPI AG in Remote Sensing
- Vol. 7 (11) , 15068-15081
Abstract
Because the Surface Energy Balance Algorithm for Land (SEBAL) tends to underestimate ET when there is advection, the model was modified by incorporating an advection component as part of the energy usable for crop evapotranspiration (ET). The modification involved the estimation of advected energy, which required the development of a wind function. In Part I, the modified SEBAL model (SEBAL-A) was developed and validated on well-watered alfalfa of a standard height of 40–60 cm. In this Part II, SEBAL-A was tested on different crops and irrigation treatments in order to determine its performance under varying conditions. The crops used for the transferability test were beans (Phaseolus vulgaris L.), wheat (Triticum aestivum L.) and corn (Zea mays L.). The estimated ET using SEBAL-A was compared to actual ET measured using a Bowen Ratio Energy Balance (BREB) system. Results indicated that SEBAL-A estimated ET fairly well for beans and wheat, only showing some slight underestimation of a Mean Bias Error (MBE) of −0.7 mm·d−1 (−11.3%), a Root Mean Square Error (RMSE) of 0.82 mm·d−1 (13.9%) and a Nash Sutcliffe Coefficient of Efficiency (NSCE) of 0.64. On corn, SEBAL-A resulted in an ET estimation error MBE of −0.7 mm·d−1 (−9.9%), a RMSE of 1.59 mm·d−1 (23.1%) and NSCE = 0.24. This result shows an improvement on the original SEBAL model, which for the same data resulted in an ET MBE of −1.4 mm·d−1 (−20.4%), a RMSE of 1.97 mm·d−1 (28.8%) and a NSCE of −0.18. When SEBAL-A was tested on only fully irrigated corn, it performed well, resulting in no bias, i.e., MBE of 0.0 mm·d−1; RMSE of 0.78 mm·d−1 (10.7%) and NSCE of 0.82. The SEBAL-A model showed less or no improvement on corn that was either water-stressed or at early stages of growth. The errors incurred under these conditions were not due to advection not accounted for but rather were due to the nature of SEBAL and SEBAL-A being single-source energy balance models and, therefore, not performing well over heterogeneous surfaces. Therefore, it was concluded that SEBAL-A could be used on a wide range of crops if they are not water stressed. It is recommended that the SEBAL-A model be further studied to be able to accurately estimate ET under dry and sparse surface conditions.Keywords
This publication has 21 references indexed in Scilit:
- SEBAL-A: A Remote Sensing ET Algorithm that Accounts for Advection with Limited Data. Part I: Development and ValidationRemote Sensing, 2015
- Application of SEBAL Model for Mapping Evapotranspiration and Estimating Surface Energy Fluxes in South-Central NebraskaJournal of Irrigation and Drainage Engineering, 2008
- Accuracy of the Bowen ratio-energy balance method for measuring latent heat flux in a semiarid advective environmentIrrigation Science, 2006
- High density NOAA time series of ET in the Gediz Basin, TurkeyIrrigation and Drainage Systems, 2005
- Aerodynamic parameters and sensible heat flux estimates for a semi-arid ecosystemJournal of Arid Environments, 2004
- Downwind evolution of surface fluxes over a vegetated surface during local advection of heat and saturation deficitJournal of Hydrology, 1997
- Simplified expressions for vegetation roughness length and zero-plane displacement as functions of canopy height and area indexBoundary-Layer Meteorology, 1994
- Aerodynamic parameters for a sparsely roughened surface composed of small cotton plants and ridged soilRemote Sensing of Environment, 1990
- Aerodynamic properties of partial canopiesAgricultural and Forest Meteorology, 1989
- Evaporation from sparse crops‐an energy combination theoryQuarterly Journal of the Royal Meteorological Society, 1985