Selective Electroreduction of Carbon Dioxide over SnO2‐Nanodot Catalysts
Authors:
- 16 March 2020
- journal article
- research article
- Published by Wiley in ChemSusChem
- Vol. 13 (23) , 6353-6359
Abstract
The development of electrochemical CO2conversion allows green carbon utilization. Formate and syngas are two typical products of electrochemical CO2reduction, and the coproduction of these two products will maximize the energy efficiency of CO2conversion. However, few works have successfully achieved the cogeneration of formate and syngas. This paper describes a novel strategy to maximize the efficiency of CO2conversion through coproduction of formate and syngas on ultrasmall SnO2nanodots (NDs) homogeneously anchored on carbon nanotubes (CNT#SnO2NDs) electrodes. The CNT#SnO2NDs not only decreased the adsorption energy of *OCHO but also reduced the adsorption energy difference of *COOH and *H. High energy efficiency toward formate and adjustable H2/CO ratio were obtained over a broad potential window with long‐term stability. In addition, CNT#SnO2NDs and Ir foil were coupled together to construct an electrolyzer for electrochemical CO2reduction reaction and oxygen evolution reaction (CO2ERR–OER), which also produced formate and syngas with 24 h stability. A promising approach is presented for the electrochemical CO2conversion in fuel production.Keywords
Funding Information
- National Natural Science Foundation of China (21525626)
This publication has 45 references indexed in Scilit:
- The Electrochemical Reduction of Carbon Dioxide to Formate/Formic Acid: Engineering and Economic FeasibilityChemSusChem, 2011
- How copper catalyzes the electroreduction of carbon dioxide into hydrocarbon fuelsEnergy & Environmental Science, 2010
- Fischer–Tropsch Synthesis: Reaction mechanisms for iron catalystsCatalysis Today, 2009
- Facile preparation of RuO2/CNT catalyst by a homogenous oxidation precipitation method and its catalytic performanceApplied Catalysis A: General, 2007
- Single-Step Syngas-to-Dimethyl Ether Processes for Optimal Productivity, Minimal Emissions, and Natural Gas-Derived SyngasIndustrial & Engineering Chemistry Research, 1999
- From ultrasoft pseudopotentials to the projector augmented-wave methodPhysical Review B, 1999
- Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis setPhysical Review B, 1996
- Characterization of polyamic acid/polyimide films in the nanometric thickness range from spin‐deposited polyamic acidSurface and Interface Analysis, 1988
- Mechanism of high-temperature oxidation of tin selenideJournal of Materials Science, 1986
- Special points for Brillouin-zone integrationsPhysical Review B, 1976