A CMOS rotary encoder using magnetic sensor arrays
Authors:
- 6 September 2005
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 5 (5) , 889-894
Abstract
A new type of small magnetic rotary encoder is presented. The device detects the magnetic field of a permanent magnet attached to the end of the rotating shaft using complementary metal-oxide semiconductor (CMOS) magnetic sensors [magnetic field effect transistor (MAGFET) arrays] set in a square arrangement. The sensor array is integrated onto a CMOS chip along with angle-detection circuits, leading to the realization of a compact, cost-effective rotary encoder. A prototype sensor chip with dimensions of 4.3/spl times/4.3 mm/sup 2/ is shown to provide error as low as 3.5/spl deg/ without offset calibration and 0.36/spl deg/ with offset calibration, based on an angle calculation method with mean square estimation. This result shows that the CMOS rotary encoder can achieve resolution of 10 bits/rotation at the cost of calibration.Keywords
This publication has 6 references indexed in Scilit:
- A CMOS smart rotary encoder using magnetic sensor arrays2004
- Two-dimensional magnetic microsensor with on-chip signal processing for contactless angle measurementIEEE Journal of Solid-State Circuits, 1996
- Modelling of split-drain magnetic field-effect transistor (MAGFET)Sensors and Actuators A: Physical, 1995
- Split-drain MOSFET magnetic sensor arraysSensors and Actuators A: Physical, 1990
- Integrated semiconductor magnetic field sensorsProceedings of the IEEE, 1986
- Two-dimensional numerical modeling of magnetic-field sensors in CMOS technologyIEEE Transactions on Electron Devices, 1985