Wear Characteristics of Al 6061 Reinforced with Graphite under Different Loads and Speeds
Authors:
- 4 July 2011
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 287-290, 998-1002
Abstract
This work investigates Al 6061 alloy with graphite particle impregnated metal matrix composites under dry sliding conditions. The conventional casting techniques were used for preparing the composite material. Experiments were conducted under dry sliding conditions for determining the wear behavior of Al 6061 alloy- Graphite composite material with varying wt % graphite content under different sliding speeds and at different loads. Sliding distance of 250m was commonly used for the wear test. A pin on disc machine was used for conducting the wear test. The test was conducted under atmospheric conditions. Wear rate decreases with increased sliding speed and increases with increasing load. Worn surfaces of the composites were examined through scanning electron microscope. The wear loss of the composite material with 5Wt % graphite was found to be minimum with respect to sliding speeds and loads.Keywords
This publication has 15 references indexed in Scilit:
- Influence of graphite content on the dry sliding and oil impregnated sliding wear behavior of Al 2024–graphite composites produced by in situ powder metallurgy methodWear, 2009
- The role of tribo-layers on the sliding wear behavior of graphitic aluminum matrix compositesWear, 2001
- A study on process and tribological behavior of Al alloy/Gr. (p) compositeWear, 1998
- Wear mechanisms in hybrid composites of Graphite-20 Pct SiC in A356 Aluminum Alloy (Al-7 Pct Si-0.3 Pct Mg)Metallurgical and Materials Transactions A, 1995
- Metal-matrix composites: Manufacturing aspects. Part IJournal of Materials Processing Technology, 1993
- Microstructure and wear of cast (Al-Si alloy)-graphite compositesWear, 1989
- Wear of cast Al-Si alloys containing graphiteWear, 1984
- Scanning electron microscopy studies of wear in LM13 and LM13-graphite particulate compositeWear, 1982
- The UPAL process: a direct method of preparing cast aluminium alloy-graphite particle compositesJournal of Materials Science, 1981
- Wear resistance of cast graphitic aluminium alloysWear, 1974