Vibratory monitoring of a spalling bearing defect in variable speed regime
- 12 June 2013
- journal article
- research article
- Published by EDP Sciences in Mechanics & Industry
- Vol. 14 (2) , 129-136
Abstract
Rotating machines monitoring in a non-stationary regime, characterized by the operating parameters (speed, load) variation, presents a particular challenge. The speed variation has an impact on the vibratory response given by the accelerometers and therefore masks any defect that may be detected by classical indicators (for example RMS value). To overcome this problem, a new indicator is proposed. For this, a signal accelerometer and a signal from an optical encoder are acquired simultaneously. An algorithm to estimate the instantaneous speed from the signal delivered by the optical encoder is applied. Then, each sample of the accelerometer signal is divided by its corresponding instantaneous speed sample. The RMS value is then applied to the resulting signal. A model simulation signal is used to test the proposed method. A test rig is performed to extract signals of different degradation states of thrust bearings in variable speed regime. The results show a correlation between the proposed RMS value and the thrust bearings state in variable regime.Keywords
This publication has 15 references indexed in Scilit:
- Rolling element bearing diagnostics—A tutorialMechanical Systems and Signal Processing, 2011
- Fuzzy Diagnosis Method for Rotating Machinery in Variable Rotating SpeedIEEE Sensors Journal, 2010
- Detection of signal transients based on wavelet and statistics for machine fault diagnosisMechanical Systems and Signal Processing, 2009
- Cyclic spectral analysis in practiceMechanical Systems and Signal Processing, 2007
- A review on machinery diagnostics and prognostics implementing condition-based maintenanceMechanical Systems and Signal Processing, 2006
- A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearingsTribology International, 1999
- The vibration produced by multiple point defects in a rolling element bearingJournal of Sound and Vibration, 1985
- Model for the vibration produced by a single point defect in a rolling element bearingJournal of Sound and Vibration, 1984
- Vibration monitoring of rolling element bearings by the high-frequency resonance technique — a reviewTribology International, 1984
- Mechanical Fault Diagnosis and condition monitoring1977