The effect of austenite reversion on the microstructure and mechanical properties of a 12Cr–3Ni–3Mn–3Cu-0.15Nb–0.05C maraging stainless steel
Authors:
- Vinothkumar GovindarajVGVinothkumar Govindaraj
- Peter HodgsonPHPeter Hodgson
- Rajkumar P SinghRSRajkumar P Singh
- Hossein BeladiHBHossein Beladi
- 1 November 2021
- journal article
- research article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 828
Abstract
No abstract availableKeywords
This publication has 24 references indexed in Scilit:
- The influence of tempering temperature on the reversed austenite formation and tensile properties in Fe–13%Cr–4%Ni–Mo low carbon martensite stainless steelsMaterials Science and Engineering: A, 2011
- Temperature Dependence of Austenite Nucleation Behavior from Lath MartensiteISIJ International, 2011
- Formation of the reversed austenite during intercritical tempering in a Fe–13%Cr–4%Ni–Mo martensitic stainless steelMaterials Letters, 2010
- Microstructural evolution and low temperature impact toughness of a Fe–13%Cr–4%Ni–Mo martensitic stainless steelMaterials Science and Engineering: A, 2010
- The morphology and crystallography of lath martensite in alloy steelsActa Materialia, 2006
- Study of the influence of alloying elements on Cu precipitation in steel by non-classical nucleation theoryActa Materialia, 2006
- Crystallographic features of lath martensite in low-carbon steelActa Materialia, 2006
- Effect of microstructure on the stability of retained austenite in transformation-induced-plasticity steelsMetallurgical and Materials Transactions A, 2004
- Amount of retained austenite at room temperature after reverse transformation of martensite to austenite in an Fe–13%Cr–7%Ni–3%Si martensitic stainless steelScripta Materialia, 2001
- Effect of δ' precipitates on serrated flowScripta Metallurgica et Materialia, 1995