Evaluation of polymerization shrinkage in dental restorative experimental composites based: BisGMA/TEGDMA, filled with MMT
- 9 March 2016
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 133 (24)
Abstract
This work concerns to the investigation of the polymerization shrinkage and mechanical properties in dental restoratives experimental composites filled with nano clay Montmorilonite (MMT) Cloisite® 10A nanoparticles, in glycidyl methacrylate resin, using experimental composites filled with silanized Aerosil OX‐50 Silica as a control group. Six formulations with BisGMA/TEGDMA based polymeric matrix (three added with MMT and three added with silanized silica as filler) containing 50, 60, and 70 wt % were investigated. Characterization of the experimental composites was established with the following analyses: Scanning Electron Microscope, (SEM); Thermo‐Mechanical Analysis, (TMA) for Shrinkage Polymerization; Differential Scanning Calorimetry Analysis (DSC); Knoop Micro Hardness analysis; X‐ray Diffraction (XRD); Degree of Conversion (DC); Elastic Modulus and Flexural Strength; Transmission Electron Microscopy (TEM). Statistical Analyses were realized using two‐way ANOVA (type and amount of filler) and Tukey's test. TMA results showed that composites filled with MMT nanoparticle present statistically lower polymerization shrinkage values and statistically high degree of conversion in all formulations tested, when compared to composites filled with silanized silica. XRD and TEM analyses showed evidences of the intercalation phenomenon in the MMT nanoparticles in relation to BisGMA/TEGDMA polymeric matrix. However, for Flexural Strength, groups filled with MMT nanoparticle showed statistically lower values in all concentration tested. At high filler concentration it was observed the appearance of tactoids and functionalization of MMT nanoparticle did not promote a strong interface adhesion between polymeric matrix and filler. In order to adjust the mechanical properties, it would be convenient to promote the concentration optimization of MMT nanoparticles. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016, 133, 43543.Keywords
This publication has 28 references indexed in Scilit:
- BisGMA/TEGDMA ratio and filler content effects on shrinkage stressDental Materials, 2011
- Preparation and characterization of light‐cured methacrylate/montmorillonite nanocompositesPolymer International, 2010
- Effect of shrinkage strain, modulus, and instrument compliance on polymerization shrinkage stress of light-cured composites during the initial curing stageDental Materials, 2010
- Investigation of Mechanical Properties of Experimental Bis-GMA/TEGDMA Dental Composite Resins Containing Various Mass Fractions of Silica NanoparticlesJournal of Prosthodontics, 2010
- Influence of BisGMA, TEGDMA, and BisEMA contents on viscosity, conversion, and flexural strength of experimental resins and compositesEuropean Journal of Oral Sciences, 2009
- Thermal degradation of commercially available organoclays studied by TGA–FTIRThermochimica Acta, 2007
- Epoxy-silicate nanocomposites: Cure monitoring and characterizationMaterials Science and Engineering: A, 2007
- Polymer/layered silicate nanocomposites: a review from preparation to processingProgress in Polymer Science, 2003
- Aqueous polymerization of protonated 4-vinylpyridine in montmorilloniteApplied Clay Science, 2001
- Polymer-layered silicate nanocomposites: preparation, properties and uses of a new class of materialsMaterials Science and Engineering: R: Reports, 2000