Ultrasonic-assisted low-temperature Cu–Cu bonding of bimodal particles for power electronics interconnects: effects on microstructure and joint properties
Authors:
- Yi ChenYCYi Chen
- Yunxia LiuYLYunxia Liu
- Qingyun YuQYQingyun Yu
- Yang LiuYLYang Liu
Preprint
- 12 October 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Low-temperature sintering of Cu particles has considerable potential for advanced power electronic packaging, but surface oxidation and insufficient atomic diffusion at low temperatures limit the performance of sintering joints. In this paper, an ultrasonic-assisted sintering process was proposed and optimized, and the effect of the ultrasonic process and sintering temperature on the microstructure and properties of the Cu-Cu sintered joints was investigated. Without ultrasonic assistance, the average shear strength increased from 6.12 MPa to 46.73 MPa as the sintering temperature increased from 200°C to 240 °C, which was primarily attributable to the temperature promoting atomic diffusion. The joint performance showed a trend of increasing first and then decreasing with the increase of ultrasonic power and duration under the ultrasonic-assisted process at 200°C. The best performance was obtained at 600 W for 4 s, giving a shear strength of 43.35 MPa, approximately 7.1 times higher than that without ultrasonic assistance at 200°C, approaching the shear strength of the sintered joint without ultrasonic-assisted sintering at 240℃. However, excessively high ultrasonic power and duration could damage the sintered layer, cause micro-cracks, and reduce performance. Microstructural analysis indicates that moderate ultrasonic treatment could promote surface-oxide disruption, particle rearrangement, and plastic deformation, thereby facilitating atomic diffusion and sintering-neck growth at low temperatures, and transforming the fracture path from interface separation to internal cohesive fracture. This study proposed an ultrasonic-assisted process for copper particle low-temperature sintering and elucidated its strengthening mechanism, providing a basis for Cu-Cu bonding in low thermal budget power devices.Keywords
This publication has 24 references indexed in Scilit:
- Ligand‐Engineered Cu@Ni Core‐Shell Nanoparticles with Excellent Performance for Printed ElectronicsAdvanced Materials Technologies, 2025
- Low-temperature copper sinter-joining technology for power electronics packaging: A reviewJournal of Materials Processing Technology, 2024
- Ultrasonic-enhanced silver‑indium transient liquid phase bonding in advancing rapid and low-temperature packagingMaterials Characterization, 2024
- Molecular dynamics study of acoustic softening effect in ultrasonic vibration assisted tension of monocrystalline/polycrystalline coppersJournal of Materials Processing Technology, 2022
- Sintering mechanism of copper nanoparticle sphere-plate of crystal misalignment: A study by molecular dynamics simulationsJournal of Materials Research and Technology, 2021
- Influence of Cu micro/nano-particles mixture and surface roughness on the shear strength of Cu-Cu jointsJournal of Materials Processing Technology, 2018
- Exothermic low temperature sintering of Cu nanoparticlesMaterials Characterization, 2015
- Bonding strength of multiple SiC die attachment prepared by sintering of Ag nanoparticlesJournal of Materials Processing Technology, 2015
- A Review on Die Attach Materials for SiC-Based High-Temperature Power DevicesMetallurgical and Materials Transactions B, 2010
- Deformation twinning in polycrystalline copper at room temperature and low strain rateActa Materialia, 2006