Creep and Recovery of Polyolefin Foams—Deformation Mechanisms
Authors:
- 1 May 1997
- journal article
- research article
- Published by SAGE Publications in Journal of Cellular Plastics
- Vol. 33 (3) , 264-292
Abstract
The effects of gas compression and Poisson's ratio on the compressive stress-strain curves of closed cell foams have been analysed. The contributions of hardening, polymer viscoelasticity, and gas escape on creep are examined. The foam diffusivity for air was predicted from the polymer permeability and the foam density. Diffusivity values, derived from fitting creep curves of LDPE and EVA foams, are of the correct order of magnitude. Creep is dominated by the polymer viscoelasticity if the stress is less than the yield stress, but at higher stresses gas compression takes an increasing proportion of the load. Gas escape is a creep mechanism operating on a timescale that depends on the size of the foam block. The consequences of the high gas diffusivity on the creep design for polyolefin foams are discussed.Keywords
This publication has 10 references indexed in Scilit:
- The Effect of Water Immersion on the Mechanical Properties of Polystyrene Bead Foam Used in Soft Shell Cycle HelmetsJournal of Cellular Plastics, 1994
- Thermal ageing1994
- The effect of drawing on the transport of gases through polyethyleneJournal of Polymer Science Part B: Polymer Physics, 1993
- The Mechanism of the Recovery of Impacted High Density Polyethylene FoamCellular Polymers, 1991
- Creep of polymer foamsJournal of Materials Science, 1991
- Measurements of the Rate of Gas Diffusion in Rigid Cellular PlasticsJournal of Thermal Insulation, 1989
- Ethylene Homo and Copolymer FoamsCellular Polymers, 1988
- Aging of polyurethane foamsInternational Journal of Heat and Mass Transfer, 1986
- Load‐compression behavior of brittle foamsJournal of Applied Polymer Science, 1970
- Statistical description of the uniaxial creep behavior of polypropylene foamJournal of Applied Polymer Science, 1967