Numerical study on heat transfer and pressure drop characteristics of R410A condensation in horizontal circular mini/micro‐tubes
- 9 June 2016
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 94 (9) , 1809-1819
Abstract
Heat transfer and pressure drop characteristics of condensation for R410A inside horizontal circular tubes with inner diameters ranging from 0.25–4 mm were investigated numerically. The effects of mass flux, vapour quality, tube diameters, and gravity on heat transfer and pressure drop characteristics were discussed. Liquid‐vapour interfaces and stream‐traces were also presented to give a better understanding of these effects on the condensing flow. Numerical heat transfer coefficients and pressure gradients fitted well with the empirical correlations. The results indicate that local heat transfer coefficients and pressure drop increase with increasing mass flux, vapour quality, and with decreasing tube diameters. A thin liquid film is formed at the upper part of the tube in mini‐channels, while a symmetrical annular flow is observed in microchannels. A vortex with its core lying at the bottom of the tube is formed in the tubes with an inner diameter of 4 mm, while the stream‐traces start from the z‐axis and point to the liquid‐vapour interface when dh is 0.25 mm. The gravity effect on heat transfer is important in larger tubes at lower vapour quality, where stratified flow may occur.Keywords
Funding Information
- National Science Foundation of China (51210011)
This publication has 33 references indexed in Scilit:
- Numerical Simulation of Laminar Liquid Film Condensation in a Horizontal Circular MinichannelJournal of Heat Transfer, 2012
- Theoretical model for annular flow condensation in rectangular micro-channelsInternational Journal of Heat and Mass Transfer, 2012
- Theory of heat transfer during condensation in microchannelsInternational Journal of Heat and Mass Transfer, 2011
- Numerical and experimental investigation of two phase flow during boiling in a coiled tubeInternational Journal of Heat and Mass Transfer, 2008
- Condensation in horizontal tubes, part 1: two-phase flow pattern mapInternational Journal of Heat and Mass Transfer, 2003
- Condensation in horizontal tubes, part 2: new heat transfer model based on flow regimesInternational Journal of Heat and Mass Transfer, 2003
- Flow condensation heat transfer coefficients of pure refrigerantsInternational Journal of Refrigeration, 2003
- Condensation in Smooth Horizontal TubesJournal of Heat Transfer, 1998
- Two-equation eddy-viscosity turbulence models for engineering applicationsAIAA Journal, 1994
- A general correlation for heat transfer during film condensation inside pipesInternational Journal of Heat and Mass Transfer, 1979