Contribution of ultrasonic to microstructure and mechanical properties of tilt probe penetrating friction stir welded joint
Authors:
- Yanying HuYHYanying Hu
- Huijie LiuHLHuijie Liu
- Dongrui LiDLDongrui Li
- 1 September 2021
- journal article
- research article
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 85, 205-217
Abstract
No abstract availableKeywords
This publication has 32 references indexed in Scilit:
- Effect of welding parameters on microstructure and mechanical properties of friction stir welded joints of AA7039 aluminum alloyMaterials & Design (1980-2015), 2012
- Influence of friction stir welding process and tool parameters on strength properties of AA7075-T6 aluminium alloy jointsMaterials & Design (1980-2015), 2011
- Mobility of low-angle grain boundaries in pure metalsPhilosophical Magazine, 2010
- Effects of heat input on tensile properties and fracture behavior of friction stir welded Mg–3Al–1Zn alloyMaterials Science and Engineering: A, 2010
- Evaluation of fatigue strength of friction stir butt-welded aluminum alloy joints inclined to applied cyclic stressInternational Journal of Fatigue, 2008
- Effect of zigzag line on the mechanical properties of friction stir welded joints of an Al–Cu alloyScripta Materialia, 2006
- Deformation Induced Vacancies with Severe Plastic Deformation: Measurements and ModellingMaterials Science Forum, 2006
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Modelling the effect of deformation-induced vacancies on segregation and precipitationActa Metallurgica et Materialia, 1994
- The effect of quench rate on the aging of alpha ironActa Metallurgica, 1972