Residual stress in sputtered gold films on quartz measured by the cantilever beam deflection technique
Authors:
- F. EricsonFEF. Ericson
- C. HedlundCHC. Hedlund
- J. OhrmaimJOJ. Ohrmaim
- J.-A. SchweitzJSJ.-A. Schweitz
- G. PortnoffGPG. Portnoff
- 1 July 1999
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 46 (4) , 981-992
Abstract
With resonator applications in mind, the residual stress in sputtered gold electrodes on quartz has been investigated with respect to various deposition rates (2, 10, and 50 /spl Aring//s), pressures (1.0 and 3.0 10/sup -3/ mbar), deposition temperatures (80/spl deg/C and room temperature (RT)), film thicknesses (approx. 400 to 800 /spl Aring/), and substrate smoothnesses (lapped and polished), using the cantilever beam deflection method. Samples were monitored for 4 weeks at room temperature followed by 13 weeks of annealing at 85/spl deg/C. The initial stress (ranging from -180 to -60 MPa) was compressive for all samples but turned tensile (a few megaPascals) in some of the samples after annealing. A significant decrease in initial compressive stress appeared with samples coated at an elevated temperature. From samples prepared at lower pressure and differing only in film thickness and substrate roughness, an increased compressive stress was found in thicker films and on rougher surfaces. The stress relaxation has been fitted to an exponential expression, and an attempt to relate the stress to a frequency shift (typically a few parts per million for ordinary, 100-/spl mu/m thick AT blanks) has been made. With the help of transmission electron microscopy (TEM) the film morphology was investigated and related to the deposition parameters and aging. Judging from the increase in compressive stress and grain refinement with increased deposition rate and decreased pressure, the atomic peening mechanism is the most likely reason for the induced stress. Rutherford backscattering spectrometry (RBS) was employed to rule out the inclusion of argon (below or around 0.5%) as an explanation. From the vague, but clearly discernible, trend toward faster RT stress relaxation with higher initial stress, together with the finer film morphology, the relief mechanism is believed to be stress-promoted grain boundary diffusion.Keywords
This publication has 24 references indexed in Scilit:
- Stresses in thin film metallizationIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A, 1997
- Resistivity and adhesive strength of thin film metallizations on single crystal quartzIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1997
- Influence of surface coatings on elasticity, residual stresses, and fracture properties of silicon microelementsJournal of Applied Physics, 1989
- Crystals for quartz resonatorsReviews of Modern Physics, 1985
- Mechanical properties of optical filmsThin Solid Films, 1982
- Modification of evaporated chromium by concurrent ion bombardmentJournal of Vacuum Science and Technology, 1980
- Analysis of Quartz Resonator Electrodes Using the Rutherford Backscattering Technique1980
- Internal stresses in metallic films deposited by cylindrical magnetron sputteringThin Solid Films, 1979
- Aluminum films deposited by rf sputteringMetallurgical Transactions, 1970
- The tension of metallic films deposited by electrolysisProceedings of the Royal Society of London. Series A, Containing Papers of a Mathematical and Physical Character, 1909