Comparative study of tribological performance between micro/nano Cu reinforced Al–Fe matrix composite
- 1 October 2026
- journal article
- Published by IOP Publishing in Engineering Research Express
- Vol. 8 (20) , 205508
Abstract
Aluminum metal matrix composites possess unique properties, including availability, lightweight characteristics, and high strength. This study aims to investigate Al reinforced with 10 vol.% Fe and 0–4 vol.% dual-scale particles of Micro/Nano-sized copper via powder metallurgy (PM). The investigation encompasses mechanical properties, including hardness and wear, as well as physical properties such as relative density. Dry sliding wear was assessed under 5–20 N at 1.5 m s −1 for 1810 m in a factorial design (Cu type × Cu content × load), yielding 48 experimental runs. The results showed that the relative density of both hybrids decreased significantly (Micro: 4.56%; Nano: 3.56%) as the Cu content increased, with the Nano-Cu composites having a higher density than the Micro-Cu composites. The microhardness of the hybrid composite increased significantly, reaching up to 61%, with a higher Micro-Cu content. For Nano-Cu, microhardness improved by up to 55% at 3 vol.% before decreasing up to 17%. Composites with Micro-Cu exhibited higher hardness than those with Nano-Cu. Analysis of variance of a full factorial design revealed that applied load, copper content, and copper type significantly impact wear performance, with contributions of 63.9%, 14.7%, and 6.2%, respectively. Micro-Cu composites exhibited greater wear resistance than Nano-Cu composites. Besides, wear loss initially decreased with increasing Cu concentration up to 3 vol.%, then increased slightly. Wear loss positively correlates with applied normal loads. Lastly, Micro-Cu at about 3 vol.% in an Al–10% Fe matrix provides the best balance of densification, hardening, and dry-sliding wear resistance.Keywords
This publication has 24 references indexed in Scilit:
- Enhanced mechanical properties of aluminum matrix composite reinforced by bimodal-sized (submicron + nano) particlesJournal of Alloys and Compounds, 2025
- Microstructure and wear behavior of aluminum matrix composites reinforced with copper-coated cubic boron nitride nanoparticlesTribology International, 2025
- Metal matrix composites: revolutionary materials for shaping the futureDiscover Materials, 2025
- Effects of various fabrication techniques on the mechanical characteristics of metal matrix composites: a reviewAdvances in Materials and Processing Technologies, 2022
- Additive Manufacturing of Aluminum‐Based Metal Matrix Composites—A ReviewAdvanced Engineering Materials, 2021
- Mechanical performance of micro-Cu and nano-Ag reinforced Al-CNT composite prepared by powder metallurgy techniqueMaterials Research Express, 2019
- A statistical prediction on wear and friction behavior of ZrC nano particles reinforced with Al Si composites using full factorial designSurfaces and Interfaces, 2018
- Optimizing the Dry Sliding Wear Behavior of Copper Hybrid Nano Composites Reinforced with MWCNTs and Nano B4C Using Full Factorial DesignTransactions of the Indian Institute of Metals, 2015
- Effect of iron addition on microstructure, mechanical and magnetic properties of Al-matrix composite produced by powder metallurgy routeTransactions of Nonferrous Metals Society of China, 2015
- Wear behavior of Al–Cu and Al–Cu/SiC components produced by powder metallurgyJournal of Materials Science, 2008