Analytical Scaling Model for Hydrocarbon Emissions From Fuel Absorption in Oil Layers in Spark Ignition Engines
Authors:
- 1 November 1995
- journal article
- research article
- Published by Taylor & Francis in Combustion Science and Technology
- Vol. 109 (1-6) , 205-226
Abstract
Cyclic absorption and desorption of fuel by the lubricating oil layer on the cylinder wall has been suggested as a significant source of unburned hydrocarbon emissions from spark ignition engines. A simple analytical model describing this dynamic process as unsteady one-dimensional cyclic absorption and desorption of a dilute amount of gas in a thin liquid layer on an impervious wall has been developed. A general solution for a periodic variation in fuel concentration in the gas phase is obtained, and three distinct limits for the net absorption of hydrocarbons are shown to exist depending on the relative time scales for the hydrocarbon concentration forcing function, the diffusion in the liquid and in the gas phase. A general criterion for when gas-phase convection species transfer resistance must be taken into account is also derived. Focus was given to the relative importance of the gas-phase and liquid-phase diffusion rates, and the scaling of the hydrocarbon absorption phenomena with realistic engine operating conditions. Therefore, physical properties, such as oil layer temperature, oil layer thickness, solubility, and transport coefficients were estimated by empirical correlations relating them to the engine operating condition rather than as constant inputs. Calculated results show that under typical conditions, the rate of absorption expressed as a percentage of the total charge is primarily a function of fuel component solubility and engine operating temperature. The absolute rate of absorption scales linearly with load, and the sensitivity to speed depends on the operating temperature. At low temperatures, where diffusion and convection species transfer are controlling, the rate of absorption and desorption decreases with increasing engine speed. At normal operating temperatures however, oil layer thickness rather than species transfer is controlling and the process becomes nearly independent of engine speed.Keywords
This publication has 10 references indexed in Scilit:
- Solubility of gasoline components in different lubricants for combustion engines determined by gas—liquid partition chromatographyJournal of Chromatography A, 1991
- A study of HC emission from a spark ignition engine. (The influence of fuel absorbed into cylinder lubricating oil film)JSME International Journal, 1987
- The Effect of Oil Layers on Hydrocarbon Emissions: Low Solubility OilsCombustion Science and Technology, 1984
- The Effect of Oil Layers on the Hydrocarbon Emissions from Spark-Ignited EnginesCombustion Science and Technology, 1982
- Correlations for prediction of molecular diffusivities in liquidsThe Canadian Journal of Chemical Engineering, 1982
- Cyclic Absorption/Desorption of Gas in a Liquid Wall FilmCombustion Science and Technology, 1981
- Correlations for the Viscosity and Prandtl Number of Hydrocarbon-Air Combustion ProductsCombustion Science and Technology, 1980
- Thermodynamic properties of solute molecules at infinite dilution determined by gas-liquid chromatographyJournal of Chromatography A, 1975
- A Liquid Viscosity-Temperature-Chemical Constitution Relation for Organic CompoundsIndustrial & Engineering Chemistry Fundamentals, 1972
- A thermodynamic correlation of gas solubilitiesAIChE Journal, 1961