Ultra‐high molecular weight polyethylene micro‐ribbon fibers gel spun using orange terpenes
- 9 February 2024
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 64 (4) , 1743-1755
Abstract
Toxic, hazardous petrochemical solvents are commonly used for industrial‐scale ultra‐high molecular weight polyethylene (UHMWPE) fiber production, but orange terpenes, a byproduct of orange fruit production, present a bio‐derived, sustainable alternative. In this work, fine UHMWPE fibers were spun using orange terpenes as the spin solvent, hot‐drawn at a draw ratio of 5:1, investigated for their morphology, microstructure, and thermal and mechanical properties. The resulting fibers exhibited a flat, micro‐ribbon cross‐section, which is highly desirable for achieving high fiber volume fractions in UHMWPE‐fiber reinforced composites. After drawing, the fibers possessed 4× greater breaking tenacity than any previously published studies on UHMWPE fibers spun using orange terpenes with a tenacity of 8.6 cN/dtex and tensile modulus of 229.2 cN/dtex. Microstructural analysis via differential scanning calorimetry and X‐ray diffraction revealed that the hot drawing process significantly increased molecular orientation, but crystallinity decreased due to crystallite melting during drawing. Therefore, the mechanical properties of these fibers may be significantly improved with optimization of the fiber drawing process. This work establishes the strong potential of orange terpenes as an environmentally‐friendly alternative solvent for UHMWPE gel spinning and sets a foundation for future parametric optimization of the spinning and drawing of these fibers.Highlights: Micro‐ribbon ultra‐high molecular weight polyethylene fibers were prepared using bio‐solvent orange terpenes. Flat profile enables tight packing, aspect ratio maintained after drawing. Drawn fibers were 4× stronger than any previous work with orange terpenes. Near‐melt drawing reduced crystallinity, improved molecular alignment.Keywords
Funding Information
- Hydrogen and Fuel Cell Technologies Office
- U.S. Department of Energy (DE‐EE0009239)
This publication has 39 references indexed in Scilit:
- Morphology, Chain Dynamics, and Domain Sizes in Highly Drawn Gel-Spun Ultrahigh Molecular Weight Polyethylene Fibers at the Final Stages of Drawing by SAXS, WAXS, and 1H Solid-State NMRMacromolecules, 2011
- Ultra high molecular weight polyethylene: Mechanics, morphology, and clinical behaviorJournal of the Mechanical Behavior of Biomedical Materials, 2009
- Research on the molecular entanglement and disentanglement in the dry spinning process of UHMWPE/decalin solutionJournal of Applied Polymer Science, 2006
- Molecular structure and orientation of gel‐spun polyethylene fibersJournal of Applied Polymer Science, 2006
- The combined effects of crosslinking and high crystallinity on the microstructural and mechanical properties of ultra high molecular weight polyethyleneBiomaterials, 2006
- Investigation on dry spinning process of ultrahigh molecular weight polyethylene/decalin solutionJournal of Applied Polymer Science, 2005
- Preparation of a Poly(methyl methacrylate)/Ultrahigh Molecular Weight Polyethylene Blend Using Supercritical Carbon Dioxide and the Identification of a Three-Phase Structure: An Atomic Force Microscopy StudyMacromolecules, 2002
- Structure Development upon Melt Drawing of Ultrahigh Molecular Weight Polyethylene: Effect of Prior Thermal HistoryMacromolecules, 2000
- Melt Drawability of Ultrahigh Molecular Weight PolyethyleneMacromolecules, 1999
- Structure-property analysis for gel-spun, ultrahigh molecular mass polyethylene fibersJournal of Macromolecular Science, Part B, 1996