Oxide-Layer Thickness Effect for Surface Roughness Using Low-Pressure Arc
Authors:
- T. IwaoTIT. Iwao
- Y. InagakiYIY. Inagaki
- A. SatoASA. Sato
- M. YumotoMYM. Yumoto
- 14 August 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 34 (4) , 1223-1228
Abstract
Low-pressure arc cleaning is a process for removing an oxide layer. Currently, chemical and mechanical means are typically used to remove such layers. However, both methods present difficulties such as a liquid waste, dust, and noise. Regarding the low-pressure arc cleaning, waste comes from one source: the oxide layer. In addition, the cathode spot has very high temperatures that are sufficient to remove the oxide layer. This paper describes the removal of the nanometer-thick oxide layer from a thin metal plate. An oxide layer of 27-157 nm was removed, thereby, obtaining a smooth surface whose respective arithmetical mean height (Ra) and average length of an outline curve element (R sm) are 0.04 and 6.4 mum. In that case, Ra and R sm increased with an increasing oxide-layer thickness at 397-1680 nm. Those results depend on the oxide-layer thickness. Therefore, although the surface is cratered and rough after a cathode-spot treatment on the chemical oxide layer (6.7 nm), a smooth surface is obtainable after the cathode-spot treatment on the thermal oxide layer (27, 66, and 157 nm). Surface roughness depends on the processing time to produce one crater, which depends on the oxide-layer thicknessKeywords
This publication has 5 references indexed in Scilit:
- Pre-treatment on metal surface for plasma spray with cathode spots of low pressure arcSurface and Coatings Technology, 2005
- State of the theory of vacuum arcsIEEE Transactions on Plasma Science, 2001
- Cathode spots of electric arcsJournal of Physics D: Applied Physics, 2001
- Removal of Oxide Layer on Metal Surface by Vacuum ArcMaterials Transactions, JIM, 1997
- Basic Erosion Processes of Oxidized and Clean Metal Cathodes by Electric ArcsIEEE Transactions on Plasma Science, 1980