EXPERIMENTAL TECHNIQUES TO CUT AND WELD COPPER BY LASER - A REVIEW
Authors:
- 1 January 1991
- journal article
- review article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 6 (4) , 577-603
Abstract
This paper reports on the cutting and welding of copper sheets using a CO2 laser. For the cutting process, the experimental data from tests on 0.2 to 4.0 mm thick copper sheets with a 2 kW CO2 laser are described. The behavior of the critical cutting speed V, cutting widths a, the product V × b and the melted volume versus the thickness (b) for a 2 kW CO2 laser using different focusing lenses has been investigated, The cutting speeds have been found to be significant and micrographic examinations have shown that the laser cutting quality is good. The laser welding of copper sheets is possible by overlapping layers of cupric oxide, CuO, with a small quantity of cuprous oxide, Cu2O grown under laser beam irradiation. This experimental approach, similar to the one used for the cutting process, allows one to increase the copper surface absorption of the laser radiation. The weld tests done in this way have shown a bad quality of the butt joint; in fact, a number of inclusions in the melted zone and growth of the copper grains surrounding the weld have always been observed. Another experimental technique has also been tested using a better coating to increase surface absorptive power without producing weld defects. The first results are interesting, though the research is still in progress. Finally, by using e pulsed Nd-YAG laser and the same coated samples - cited above - some good welds have been obtained.Keywords
This publication has 6 references indexed in Scilit:
- Thermal energy balance in laser welding processes of austenitic stainless steelsOptics and Lasers in Engineering, 1990
- The Influence And Role Of Helium And Nitrogen As Shielding Gases In 2KW CO2 Laser Welding Of Austenitic Stainless Steels : Physical, Geometrical And Technological Characterization1989
- Cutting copper sheets using CO2 lasersHyperfine Interactions, 1987
- New Problems Emerging From CO 2 Laser Material Processing: Copper To Copper And Copper To Non-Copper Welding1987
- On cutting and penetration welding processes with high power lasersOptics and Lasers in Engineering, 1985
- Tuning of a parametric model for the laser cutting of steelsOptics and Lasers in Engineering, 1981