Delamination Buckling and Growth of Composite Laminated Plates with Transverse Shear Deformation
Authors:
- 1 October 1995
- journal article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 29 (15) , 2047-2068
Abstract
An analytical method was presented to determine the delamination buckling load and the growth of one-dimensional delaminated beam-plates. In this study, the symmetry in delamination with respect to the center of the beam-plate was not assumed. The delamination was arbitrarily located in the longitudinal and thickness directions. The effects of the delamination length, and location on the buckling load and the growth were investigated with consideration of the transverse shear deformation. Results of the analysis showed that the delamination buckling load was dependent on the configuration of the delamination. For the relatively thick delamination, the buckling load of a center located delamination was higher than that of an off-center delamination. The shear deformation effect lowered the buckling loads and increased the energy-release rates. The expreiments on delaminated graphite/epoxy unidirectional specimens were also performed to determine the buckling load and to observe the growth characteristics. Results of the experiments showed good agreement with analytic results and there existed various postbuckling characteristics depending on the configuration of delamination.Keywords
This publication has 7 references indexed in Scilit:
- Shear deformation theory for compressive delamination buckling and growthAIAA Journal, 1991
- Buckling and postbuckling of delaminated composites under compressive loads including transverse shear effectsAIAA Journal, 1988
- Ultimate axial load capacity of a delaminated beam-plateAIAA Journal, 1986
- Effect of delamination of axially loaded homogeneous laminated platesAIAA Journal, 1985
- Compressive Stability of Delaminated Random Short-Fiber Composites, Part II—Experimental and Analytical ResultsJournal of Composite Materials, 1985
- The Energy-Release Rate in the Growth of a One-Dimensional DelaminationJournal of Applied Mechanics, 1984
- One dimensional modelling of failure in laminated plates by delamination bucklingInternational Journal of Solids and Structures, 1981