Short-time plasma surface modification of polymer powders in a down flowing tube reactor
Authors:
- C. ArpagausCAC. Arpagaus
- Ph. Rudolf von RohrPRPh. Rudolf von Rohr
- A. RossiARA. Rossi
- 1 October 2005
- journal article
- Published by Elsevier in Surface and Coatings Technology
- Vol. 200 (1-4) , 525-528
Abstract
No abstract availableThis publication has 13 references indexed in Scilit:
- Treatment of a Polyethylene Powder Using a Remote Nitrogen Plasma Reactor Coupled with a Fluidized Bed: Influence on Wettability and FlowabilityPlasmas and Polymers, 2003
- Surface property modification of a polyethylene powder by coupling fluidized bed and far cold remote nitrogen plasma technologiesSurface and Interface Analysis, 2002
- Surface modification of HDPE powders by oxygen plasma in a circulating fluidized bed reactorPolymer Bulletin, 2001
- Microwave plasma characteristics of a circulating fluidized bed-plasma reactor for coating of powdersSurface and Coatings Technology, 2001
- Comparison of the wetting behaviour of polyamides presented as particles and films—Influence of a plasma microwave treatmentJournal of Materials Science, 2000
- A circulating fluidised bed for plasma-enhanced chemical vapor deposition on powders at low temperaturesSurface and Coatings Technology, 1999
- Oxygen plasma surface treatment of polymer powder in a fluidized bed reactorColloids and Surfaces A: Physicochemical and Engineering Aspects, 1998
- Plasma surface treatment of HDPE powder in a fluidized bed reactorPolymer Bulletin, 1994
- Plasma surface modification of polymers for improved adhesion: a critical reviewJournal of Adhesion Science and Technology, 1993
- Surface modification of polyethylene powder using plasma reactor with fluidized bedJournal of Applied Polymer Science, 1992