Analytical method for elastic recovery prediction of air bending sheet
Open Access
- 1 January 2023
- journal article
- research article
- Published by Centre for Evaluation in Education and Science (CEON/CEES) in Journal of Applied Engineering Science
- Vol. 21 (4) , 973-981
Abstract
The estimation of the elastic recovery is of great importance during the planning of plastic deformation processes, because this estimation could reduce the number of required steps to reach the target geometry. The sheet bending process is one of the most widely used industrial processes, and that is why this paper seeks to provide an analytical model based on an elastic behavior with potential hardening of the material that could be combined with the geometric information of the process to estimate the degree of recovery of the components. The potential hardening model was selected due to its simplicity and good fit with the experimental data observed in steel sheets in this application. The effectiveness of the model was compared with the results obtained by several authors. The effectiveness of the model is significantly influenced by the parameters of the bending process and the method used to estimate the radius of curvature.Keywords
This publication has 22 references indexed in Scilit:
- An improved study on Gardiner's work based on elastoplastic analysis considering deformation historyInternational Journal of Mechanical Sciences, 2017
- Improvement of springback prediction accuracy by considering nonlinear elastoplastic behavior after stress reversalJournal of Materials Processing Technology, 2017
- Numerical and experimental analysis of elastic–plastic pure bending and springback of beams of asymmetric cross-sectionsInternational Journal of Mechanical Sciences, 2015
- Advanced Issues in springbackInternational Journal of Plasticity, 2013
- Air bending and springback of stainless steel clad aluminum sheetJournal of Materials Processing Technology, 2010
- Adaptive through‐thickness integration for accurate springback predictionInternational Journal for Numerical Methods in Engineering, 2007
- Springback determination of sheet metals in an air bending process based on an experimental workJournal of Materials Processing Technology, 2007
- Elastoplasticity beyond small deformationsActa Mechanica, 2006
- Optimisation of springback in bending processes using FEM simulation and response surface methodThe International Journal of Advanced Manufacturing Technology, 2005
- Finite element analysis of spring-back of V-bending sheet metal forming processesJournal of Materials Processing Technology, 2004