128-channel polarization-insensitive frequency-selection-switch using high-silica waveguides on Si
Authors:
- K. OdaKOK. Oda
- 1 June 1990
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 2 (6) , 441-443
Abstract
A 128-channel polarization-insensitive frequency-selection-switch (FS-SW) with 10-GHz frequency spacing is discussed. The FS-SW was fabricated on Si using low-loss GeO/sub 2/-doped high-silica waveguides, and its frequency-insensitive operation was attained by the laser trimming adjustment of a-Si film which controls waveguide birefringence. The fiber-to-fiber loss of the transmitted channel was 6.7 dB in the pigtailed FS-SW and the total crosstalk level was less than -13 dB. By using this FS-SW, a 100-channel optical frequency division multiplexing (FDM) transmission-distribution experiment at 622 M b/s over a 50-km fiber length was achieved.Keywords
This publication has 4 references indexed in Scilit:
- A 100-channel optical FDM transmission/distribution at 622 Mb/s over 50 kmJournal of Lightwave Technology, 1990
- 16-channel optical FDM distribution/transmission experiment utilising multichannel frequency stabiliser and waveguide frequency selection switchElectronics Letters, 1989
- Silica-based single-mode waveguides on silicon and their application to guided-wave optical interferometersJournal of Lightwave Technology, 1988
- Birefringence control in high-silica single-mode channel waveguides on silicon1987