Mechanical testing and analysis of composite parts adhesively joined under tensile load
- 29 April 2017
- journal article
- Published by Walter de Gruyter GmbH in Materials Testing
- Vol. 59 (5) , 459-465
Abstract
In this paper, composite parts bonded with embedded single lap joint (SLJ) subjected to tensile load were analyzed by using 3D finite element method (FEM). In the analysis, the composite parts are carbon/epoxy (AS4/3501-6) with different fiber orientation angles and the adhesive is DP 410. The models for the numerical analyses were generated by using ANSYS software package. The finite element analyses (FEA) were carried out to predict the failure loads. Stress in x-, y- and z-directions, shear stresses and the von-Mises stresses on adhesive were obtained at the time of the failure for predetermined parameters. Consequently, the effects of orientation angles, overlap widths and length, and adhesive layer were examined. The most effective parameters were determined for composite parts adhesively bonded with embedded single lap joint.Keywords
This publication has 17 references indexed in Scilit:
- Enhanced elastic-foundation analysis of balanced single lap adhesive jointsInternational Journal of Adhesion and Adhesives, 2017
- Effect of the geometry in the strength of single-lap adhesive joints of composite laminates under uniaxial tensile loadInternational Journal of Adhesion and Adhesives, 2017
- Theoretical model of adhesively bonded single lap joints with functionally graded adherendsEngineering Structures, 2016
- An efficient analysis model for functionally graded adhesive single lap jointsInternational Journal of Adhesion and Adhesives, 2016
- Damage analysis of composite–aluminium adhesively-bonded single-lap jointsComposite Structures, 2016
- Static and fatigue failure analysis of adhesively bonded thick composite single lap jointsComposites Science and Technology, 2013
- Characterising pre-preg and non-crimp-fabric composite single lap bonded jointsInternational Journal of Adhesion and Adhesives, 2011
- The effects of partial bonding in load carrying capacity of single lap jointsInternational Journal of Adhesion and Adhesives, 2011
- Creep analysis of fibre reinforced adhesives in single lap joints—Experimental studyInternational Journal of Adhesion and Adhesives, 2009
- Failure prediction and strength improvement of uni-directional composite single lap bonded jointsComposite Structures, 2008