Electrochemical Stability of Electrodeposited PEDOT:PSS Neural Stimulation Electrodes
Open Access
- 17 October 2026
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 17 (10) , 1198
Abstract
Microelectrode arrays are used for neural stimulation and recording; however, their performance is limited by the high impedance and low charge-injection capacity of conventional metallic interfaces. To overcome these challenges, a variety of coatings, including metal oxides, carbon nanotubes, and conductive polymers, are applied to improve the electrochemical performance of microelectrode arrays. Among these materials, poly(3,4-ethylenedioxythiophene):polystyrene sulfonate (PEDOT:PSS) has gained significant attention due to its low impedance, high charge-injection capacity, and compatibility with microfabrication processes. Despite these advantages, the long-term electrochemical stability of PEDOT:PSS at high levels of stimulation charge injection remains insufficiently understood. In this study, we investigated the stability of PEDOT:PSS films electrodeposited on gold microelectrodes for prolonged electrical stimulation. Voltage transient (VT) analysis revealed that PEDOT:PSS degradation occurs when the maximum cathodic excursion (Emc) exceeds –0.6 V versus Ag|AgCl. The degradation is accompanied by the appearance of asymmetric access voltages and a voltage inversion in the anodal phase of the VT. Electrochemical impedance spectroscopy (EIS) revealed a sharp increase in PEDOT:PSS impedance at negative DC bias potentials, beginning at −0.5 V and increasing as the potential became more negative. These results identified –0.6 V as an electrochemical limit for PEDOT:PSS stability on gold and implicate the reduction and de-doping of PEDOT:PSS, and sequalae, in the observed PEDOT:PSS degradation. Nonetheless, PEDOT:PSS electrodes had stable charge-injection capacities of 3.6 mC/cm2 (200 µs pulse width) over the course of 200 million pulses.Keywords
Funding Information
- National Institutes of Health (U01 3U01NS126052-03S1)
This publication has 44 references indexed in Scilit:
- Multilayer Arrays for Neurotechnology Applications (MANTA): Chronically Stable Thin‐Film Intracortical ImplantsAdvanced Science, 2023
- Stability of Thin Film Neuromodulation Electrodes under Accelerated Aging ConditionsAdvanced Functional Materials, 2022
- Poly(3,4‐ethylenedioxythiophene)‐Based Neural Interfaces for Recording and Stimulation: Fundamental Aspects and In Vivo ApplicationsAdvanced Science, 2022
- Electrode Materials for Chronic Electrical MicrostimulationAdvanced Healthcare Materials, 2021
- Sputtered ruthenium oxide coatings for neural stimulation and recording electrodesJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2020
- High‐charge‐capacity sputtered iridium oxide neural stimulation electrodes deposited using water vapor as a reactive plasma constituentJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2019
- Conductive Poly(3,4-Ethylenedioxythiophene) (PEDOT)-Based Polymers and Their Applications in Bioelectronics2019
- Chronic intracortical neural recordings using microelectrode arrays coated with PEDOT–TFBActa Biomaterialia, 2016
- Interfacing Electronic and Ionic Charge Transport in BioelectronicsChemElectroChem, 2016
- Conducting Polymers for Neural Prosthetic and Neural Interface ApplicationsAdvanced Materials, 2015