In Situ Spectroscopic Evaluation of Copper Corrosion during Electroreduction of CO2–Amine Adducts
- 11 November 2026
- journal article
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
Abstract
This work experimentally investigated the corrosion of a copper working electrode during the direct electrochemical conversion of captured CO2 sources under basic conditions. The effect of using ammonium carbamate or dimethyl ammonium dimethyl carbamate as the captured CO2 source on the observed corrosion was studied using bulk electrolysis (BE) and UV–vis or EPR spectroscopy conducted simultaneously for 24–48 h over a range of applied voltages and captured CO2 source concentrations. Over time during BE, a maximum in the absorbance was observed at 650 nm in the UV–vis, along with the formation of a blue color, and the appearance of an S = 1/2 signal detected in a flow spectroelectrochemical EPR system. The spectroelectrochemical experiments enabled the kinetics of the electrode corrosion to be evaluated. A distinct difference in rates was observed for ammonium carbamate vs dimethyl ammonium dimethyl carbamate. Characterization of the copper electrode prior to and post BE by atomic force microscopy, powder X-ray diffraction, and scanning electron microscopy indicated a rough surface that became smooth, with an increase in Cu(II) and oxide formation over time. Combined, these data offer insights towards copper electrode corrosion in the presence of amine-based captured CO2 sources.All Related Versions
Funding Information
- Lawrence Livermore National Laboratory (DE-AC52-07NA27344)
- Basic Energy Sciences (DE-SC0023427)
- California State Polytechnic University, Pomona
- Agricultural Research Institute, California State University (21-04-018)
- National Science Foundation (1834186)
- SURE
- LAEP
- McNair program
This publication has 51 references indexed in Scilit:
- Design of an Electrochemical Cell for Continuous Wave EPR Measurements of Radical IonsChemistry – A European Journal, 2024
- Electrochemistry combined with electron paramagnetic resonance (EPR) spectroscopy for studying catalytic and energy storage processesCurrent Opinion in Electrochemistry, 2023
- Restructuring and Activation of Cu(111) under Electrocatalytic Reduction ConditionsAngewandte Chemie International Edition, 2023
- Restructuring and Activation of Cu(111) under Electrocatalytic Reduction ConditionsAngewandte Chemie, 2023
- Structure of the (Bi)carbonate Adlayer on Cu(100) ElectrodesAngewandte Chemie International Edition, 2022
- Intergranular erosion corrosion of pure copper tube in flowing NaCl solutionCorrosion Science, 2022
- Atmospheric corrosion due to amine emissions from carbon capture plantsInternational Journal of Greenhouse Gas Control, 2021
- Potential‐Dependent Morphology of Copper Catalysts During CO2 Electroreduction Revealed by In Situ Atomic Force MicroscopyAngewandte Chemie International Edition, 2020
- Selective CO2 Electroreduction to Ethylene and Multicarbon Alcohols via Electrolyte‐Driven NanostructuringAngewandte Chemie International Edition, 2019
- Dynamic Changes in the Structure, Chemical State and Catalytic Selectivity of Cu Nanocubes during CO2 Electroreduction: Size and Support EffectsAngewandte Chemie International Edition, 2018