Microstructure and Properties of Al-6061 Alloy by Equal Channel Angular Extrusion for 16 Passes
- 21 September 2007
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 22 (7-8) , 819-824
Abstract
The experimental researches on Equal Channel Angular Extrusion (ECAE) process of commercial available Al-6061 alloy were conducted and the grain refinement after ECAE processing was investigated. Sixteen passes of ECAE processing at room temperature were conducted and the relationship of grain refinement with extrusion pass was established. The property enhancements after ECAE processing including ultimate tensile strength and Vickers microhardness were investigated to determine the effects of the number of ECAE passes on the mechanical properties of the extruded samples. The research presents a whole picture of ECAE processing of the alloy for up to 16 passes.Keywords
This publication has 19 references indexed in Scilit:
- Deformation Behavior Study of Multi-Pass ECAE Process for Fabrication of Ultrafine or Nanostructured Bulk MaterialsMaterials and Manufacturing Processes, 2006
- Deformation behavior of Al–1.5Mg processed using the equal channel angular pressing techniqueScripta Materialia, 2005
- Scaling up of equal-channel angular pressing and its effect on mechanical properties, microstructure, and hot workability of AA 6061Materials Science and Engineering: A, 2005
- A comparison of the properties of SPD-processed AA-6061 by equal-channel angular pressing, multi-axial compressions/forgings and accumulative roll bondingMaterials Science and Engineering: A, 2005
- Coupled Thermo‐Mechanical Analysis of Severe Plastic Deformation for Producing Bulk Nanostructured MaterialsAdvanced Engineering Materials, 2004
- Analysis of forming loads, microstructure development and mechanical property evolution during equal channel angular extrusion of a commercial grade aluminum alloyJournal of Materials Processing Technology, 2003
- Improvement of high-cycle fatigue life in a 6061 Al alloy produced by equal channel angular pressingMaterials Science and Engineering: A, 2002
- Improvement of mechanical properties for Al alloys using equal-channel angular pressingJournal of Materials Processing Technology, 2001
- Development of a submicrometer-grained microstructure in aluminum 6061 using equal channel angular extrusionJournal of Materials Research, 1997
- Materials processing by simple shearMaterials Science and Engineering: A, 1995