Comparing the factors of safety from finite element and limit equilibrium analyses in lateral support design
Open Access
- 1 December 2019
- journal article
- research article
- Published by Academy of Science of South Africa in Journal of the South African Institution of Civil Engineering
- Vol. 61 (4) , 29-41
Abstract
Soil-nails and anchors as means of lateral support in surface excavations require stability analyses as part of design. Generally, the acceptance criterion is some arbitrary 'factor of safety' which can be routinely computed using well-established principles of limit equilibrium analyses. These methods have been tested over many years and have been shown to be adequate for design. There is an increasing trend towards the use of the finite element strength reduction methods to determine factors of safety in lateral support design. Differences are often reported between factors of safety calculated using these methods. There is also a danger that engineers might use finite element modelling without full appreciation of the impact of choices and assumptions made in using the software. This paper compares the results of limit equilibrium and finite element calculations to assess factors of safety. Under certain conditions the factor of safety from the finite element strength reduction technique is comparable with limit equilibrium methods, provided that the same failure mechanism is evaluated. In addition, in the case of anchors, the same capacity must be specified in both analyses. In defining in-situ stress states, the friction angle and Poisson's ratio should be specified so as to not violate the yield criterion. Modelling parameters (mesh grading and boundary distances) were found to have relatively minor influences on the factor of safety for the strength reduction technique.Keywords
This publication has 10 references indexed in Scilit:
- Reliability-based load and resistance factors for soil-nail wallsCanadian Geotechnical Journal, 2011
- Numerical study on the optimum layout of soil–nailed slopesComputers and Geotechnics, 2008
- Two-dimensional slope stability analysis by limit equilibrium and strength reduction methodsComputers and Geotechnics, 2007
- The 2001 R.M. Hardy Lecture: The limits of limit equilibrium analysesCanadian Geotechnical Journal, 2003
- Slope stability analysis by strength reductionGéotechnique, 1999
- Slope stability analysis by finite elementsGéotechnique, 1999
- State of the Art: Limit Equilibrium and Finite-Element Analysis of SlopesJournal of Geotechnical Engineering, 1996
- Analysis for Soil Reinforcement with Bending StiffnessJournal of Geotechnical Engineering, 1992
- Corrected Field Vane Strength for Embankment DesignJournal of Geotechnical Engineering, 1983
- The Analysis of the Stability of General Slip SurfacesGéotechnique, 1965