Nickel oxide interlayer films from nickel formate–ethylenediamine precursor: influence of annealing on thin film properties and photovoltaic device performance
Open Access
- 17 April 2015
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 3 (20) , 10949-10958
Abstract
An organometallic ink based on the nickel formate–ethylenediamine (Ni(O2CH)2(en)2) complex forms high performance NiOx thin film hole transport layers (HTL) in organic photovoltaic (OPV) devices. Improved understanding of these HTLs functionality can be gained from temperature-dependent decomposition/oxidation chemistries during film formation and corresponding chemical structure-function relationships for energetics, charge selectivity, and transport in photovoltaic platforms. Investigations of as-cast films annealed in air (at 150 °C–350 °C), with and without subsequent O2-plasma treatment, were performed using thermogravimetric analysis, Fourier transform infrared spectroscopy, ultraviolet and X-ray photoelectron spectroscopy, and spectroscopic ellipsometry to elucidate the decomposition and oxidation of the complex to NiOx. Regardless of the anneal temperature, after exposure to O2-plasma, these HTLs exhibit work functions greater than the ionization potential of a prototype donor polymer poly(N-9′-heptadecanyl-2,7-carbazole-alt-5,5-(4′,7′-di-2-thienyl-2′,1′,3′-benzothiadiazole) (PCDTBT), thereby meeting a primary requirement of energy level alignment. Thus, bulk-heterojunction (BHJ), OPV solar cells made on this series of NiOx HTLs all exhibit similar open circuit voltages (Voc). In contrast, the short circuit currents increase significantly from 1.7 to 11.2 mA cm−2 upon increasing the anneal temperature from 150 °C to 250 °C. Concomitantly, increased conductivity and electrical homogeneity of NiOx thin films are observed at the nanoscale using conductive tip-AFM. Similar Voc observed for all the O2-plasma treated NiOx interlayers and variations to nanoscale conductivity suggest that the HTLs all form charge selective contacts and that their carrier extraction efficiency is determined by the amount of precursor conversion to NiOx. The separation of these two properties: selectivity and conductivity, sheds further light on charge selective interlayer functionality.Keywords
Funding Information
- Basic Energy Sciences (DE-SC0001084)
This publication has 75 references indexed in Scilit:
- Investigating the Influence of Interfacial Contact Properties on Open Circuit Voltages in Organic Photovoltaic Performance: Work Function Versus SelectivityAdvanced Energy Materials, 2013
- Evidence for near-Surface NiOOH Species in Solution-Processed NiOx Selective Interlayer Materials: Impact on Energetics and the Performance of Polymer Bulk Heterojunction PhotovoltaicsChemistry of Materials, 2011
- Selection of Metal Oxide Charge Transport Layers for Colloidal Quantum Dot LEDsACS Nano, 2009
- All-inorganic quantum-dot light-emitting devices formed via low-cost, wet-chemical processingJournal of Materials Chemistry, 2009
- Thermal properties of mixed-ligand bis(hydrazine) and bis(ethylenediamine) complexes of cobalt, nickel and copper saccharinatesThermochimica Acta, 1999
- Thermal decomposition of hexahydrated nickel iron citrateThermochimica Acta, 1996
- Degradation studies on nickel nitrate hexahydrate. Part 3. Raman and infrared analysisThermochimica Acta, 1986
- The infrared spectra (3500-140 cm?1) of the 2,2'-bipyridine, 2-aminomethylpyridine and ethylenediamine adducts and the sodium tris-compounds of cobalt(II), nickel(II) and zinc(II) acetylacetonatesTransition Metal Chemistry, 1978
- I.R. studies on the formation of basic nickelous nitrateJournal of Inorganic and Nuclear Chemistry, 1970
- The vibrational spectrum of ethylene glycolSpectrochimica Acta Part A: Molecular Spectroscopy, 1967