Using GIS to Optimize Hydraulic Analysis of Macro and Micro Scale Flow Ways for Macro Scale Wetlands Restoration—Challenges, Solutions, and Lessons Learned
The use of GIS based methods to analyze macro and micro scale flow ways within the Picayune Strand Restoration Project (PSRP) in southwest Florida is described in this paper. Restoration of 55,000 acres of nationally prominent wetlands that were profoundly impacted decades ago by the installation of roads and drainage canals in this area is currently under way. In this situation, models are a fundamental requirement for assessment of rehabilitation alternatives and for designing new hydraulic structures. The first step towards building these models was to analyze and locate the flow-ways throughout the restoration area. The intent is to do this such that a distributed hydrologic model (Gridded Surface Subsurface Hydrologic Analysis (GSSHA) was selected) can be used to perform the hydrologic and hydraulic analyses of the area. Since project requirements range from planning analysis to detailed design, modeling is being done in a series of model tiers from macro scale (thousands of feet) to micro scale (tens of feet) resolution. Reconciling these widely differing scales was not straight forward. The large scale and varying resolution introduced numerical factors that were challenging. In particular, maintaining a consistent connectivity and model structure given that some features were strongly affected by grid scale was a complicated. This is a critical issue, since maintaining a continuation of positive drainage throughout the area in a way that does not increase the potential for flooding outside the project area is a preoccupation of the modeling effort. This is not just a complex hydrologic problem, because part of the compensation for removal of canal features was to capture and discharge upstream flows through several large (several thousand cfs) pumps to spreading berms and spreading canals that approximate predeveloped overland flow conditions, in a way that does not threaten existing dwellings and vulnerable points with flooding damage. This meant that the data also needed to accommodate representation of abrupt changes in flow conditions. A complicating factor was the need to manage artifacts in the topographic data introduced by the LIDAR techniques used to gather the data, and de-corrugating processing that was applied in this project is discussed.