The Transition from to the Metallic Phase Arc After the Rupture of the Molten Metal Bridge for Contacts Opening in Air and Vacuum
Author:
- Paul G. SladePSPaul G. Slade
- 1 October 2008
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Abstract
The total arcing time between opening electrical contacts interrupting a low voltage, low current circuit in both air and vacuum was controlled. The voltage across the opening contacts showed the rupture of the molten metal bridge and then its rapid increase to a value greater than the minimum arcing voltage before dropping back to a value close to the minimum arcing voltage. Using a radioactive tracer technique it was observed that at very short arcing times there was an anomalous net transfer of contact material to the cathode. As the arcing time increased this cathode gain decreased before increasing again at longer arcing times. High-speed streak photographs of contacts opening in air at higher currents showed an initial shock wave that resulted from the rupture of the molten metal bridge and before the formation of the metallic phase arc. Similar photographs of contacts opening in vacuum showed the initiation of a metal phase arc in the region of the ruptured molten metal bridge. After the rupture of the molten metal bridge, the voltage across the contacts rose very rapidly to a value of a few 10's of volts before dropping back to a minimum value. These data will be used to discuss the rupture of the molten metal bridge, the formation of the pseudo arc in the high-pressure metal vapor resulting from the bridge rupture and the eventual development of the metallic phase arc.Keywords
This publication has 19 references indexed in Scilit:
- Electrical breakdown in atmospheric air between closely spaced (0.2 μm-40 μm) electrical contactsIEEE Transactions on Components and Packaging Technologies, 2002
- Low current arc modes of short length and time: a reviewIEEE Transactions on Components and Packaging Technologies, 2000
- Contact erosion patterns of Pd material in DC breaking arcsIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A, 1994
- Some Spectroscopic Observations of the Two Regions (Metallic Vapor and Gaseous) in Break ArcsIEEE Transactions on Plasma Science, 1973
- Fluctuation of Arc Potential Caused by Metal-Vapor Diffusion in Arcs in AirJournal of Applied Physics, 1971
- The electrical contact: the properties and rupture of the microscopic molten metal bridgeJournal of Physics D: Applied Physics, 1969
- Measurement of metal transfer in electrical contacts by the radioactive isotope methodBritish Journal of Applied Physics, 1961
- Physical Processes in Contact ErosionJournal of Applied Physics, 1958
- Bridge and Short Arc Erosion of Copper, Silver, and Palladium Contacts on BreakJournal of Applied Physics, 1956
- The Bridge Erosion of Electrical Contacts. Part I.Journal of Applied Physics, 1948