Thermo-physical Characterisation of Plasters Containing Phase Change Materials (PCMs)
Open Access
- 9 February 2024
- journal article
- research article
- Published by Springer Nature in International Journal of Thermophysics
- Vol. 45 (3) , 1-17
Abstract
The integration of phase change materials (PCMs) within building materials is an interesting strategy to improve the thermal performance of buildings, thus reducing the energy demand for heating and/or cooling. To do so, the thermo-physical characterisation of the new enhanced materials is of outmost importance which, however, is difficult to carry out due to several limitations related to the most used techniques. To overcome these, a new alternative set up was realized, which allowed the thermo-physical characterization of different plaster samples enhanced with granular organic PCM. A steady-state test was conducted maintaining constant thermal gradients through which the thermal conductivity of the materials used was estimated. Then, a two-step ramp unsteady-state test was conducted through which the specific heat and the latent heat were estimated, showing a good agreement with values provided by the PCM suppliers. The estimated properties were then validated against experimental data acquired during the monitoring activity under real outdoor conditions of different wall samples on which the PCM-enhanced plasters were applied. With the estimated properties, RMSE values were lower than 1 °C for temperatures and lower than 2.50 W·m−2 for heat fluxes.Keywords
All Related Versions
Funding Information
- Università degli Studi di Ferrara
This publication has 23 references indexed in Scilit:
- Unconventional experimental technologies available for phase change materials (PCM) characterization. Part 1. Thermophysical propertiesRenewable and Sustainable Energy Reviews, 2015
- Combining thermal energy storage with buildings – a reviewRenewable and Sustainable Energy Reviews, 2015
- Phase change materials integrated in building walls: A state of the art reviewRenewable and Sustainable Energy Reviews, 2014
- Review of passive PCM latent heat thermal energy storage systems towards buildings’ energy efficiencyEnergy and Buildings, 2013
- Thermal enhancement of plastering mortars with Phase Change Materials: Experimental and numerical approachEnergy and Buildings, 2012
- New equipment for testing steady and transient thermal performance of multilayered building envelopes with PCMEnergy and Buildings, 2011
- Improvement of the thermal behaviour of gypsum blocks by the incorporation of microcapsules containing PCMS obtained by suspension polymerization with an optimal core/coating mass ratioApplied Thermal Engineering, 2010
- Review on thermal energy storage with phase change materials and applicationsRenewable and Sustainable Energy Reviews, 2009
- A simple dynamic measurement technique for comparing thermal insulation performances of anisotropic building materialsEnergy and Buildings, 2007
- Investigation of the thermal performance of a passive solar test-room with wall latent heat storageBuilding and Environment, 1997