Evaluation of plasma treatment effects on improving adhesive–dentin bonding by using the same tooth controls and varying cross‐sectional surface areas
- 4 May 2013
- journal article
- research article
- Published by Wiley in European Journal of Oral Sciences
- Vol. 121 (4) , 355-362
Abstract
The objective of this study was to evaluate and verify the effectiveness of plasma treatment for improving adhesive–dentin interfacial bonding by performing microtensile bond‐strength (μTBS) testing using the same‐tooth controls and varying cross‐sectional surface areas. Extracted unerupted human third molars were used after removal of the crowns to expose the dentin surface. One half of each dentin surface was treated with a non‐thermal argon plasma brush, whilst the other was shielded with glass slide and used as an untreated control. Adper Single Bond Plus adhesive and Filtek Z250 dental composite were then applied as directed. The teeth thus prepared were further cut into micro‐bar specimens, with cross‐sectional sizes of 1 × 1 mm2, 1 × 2 mm2, and 1 × 3 mm2, for μTBS testing. The test results showed that plasma‐treated specimens gave substantially stronger adhesive–dentin bonding than their corresponding same‐tooth controls. Compared with their untreated controls, plasma treatment gave statistically significant higher bonding strength for specimens with a cross‐sectional area of 1 × 1 mm2 and 1 × 2 mm2, with mean increases of 30.8% and 45.1%, respectively. Interface examination using optical and electron microscopy verified that plasma treatment improved the quality of the adhesive–dentin interface by reducing defects/voids and increasing the resin tag length in dentin tubules.Keywords
This publication has 31 references indexed in Scilit:
- Biomodification to dentin by a natural crosslinker improved the resin–dentin bondsJournal of Dentistry, 2012
- Dentin surface treatment using a non‐thermal argon plasma brush for interfacial bonding improvement in composite restorationEuropean Journal of Oral Sciences, 2010
- Cell Proliferation of HaCaT Keratinocytes on Collagen Films Modified by Argon Plasma TreatmentMolecules, 2010
- Morphological and chemical characterization of bonding hydrophobic adhesive to dentin using ethanol wet bonding techniqueDental Materials, 2009
- Effects of a solubility enhancer on penetration of hydrophobic component in model adhesives into wet demineralized dentinDental Materials, 2007
- Plasma surface modification and characterization of collagen‐based artificial cornea for enhanced epithelializationJournal of Applied Polymer Science, 2007
- Comparison of interfacial characteristics of adhesive bonding to superficial versus deep dentine using SEM and staining techniquesJournal of Dentistry, 2006
- Plasma-surface modification of biomaterialsMaterials Science and Engineering: R: Reports, 2002
- Effect of HEMA on bonding to dentinDental Materials, 1992
- A critique of bond strength measurementsJournal of Dentistry, 1989