Planar Solid Oxide Fuel Cell: Electrolyte Deposited by Reactive Magnetron Sputtering and Cell Test
Authors:
- 10 December 2010
- journal article
- research article
- Published by Wiley in Fuel Cells
- Vol. 11 (2) , 158-164
Abstract
In this work the deposition of a thin YSZ electrolyte layer (< 10 μm) on a porous anode substrate is performed by sputtering Zr–Y metallic targets in argon–oxygen reactive gas mixtures under unstable deposition conditions. A plasma emission monitoring system is used to ensure a high deposition rate of the ceramic film. The deposition parameters are optimised in order to obtain a good compromise between quality, density and deposition rate for coatings realised under unstable conditions.After a short description of the experimental setup, the characterisation of the YSZ coatings is performed using scanning electron microscopy, X‐ray diffraction and permeability measurements. Then a complete cell incorporating a thin YSZ electrolyte layer (6.2 ± 0.3 μm thick) obtained by magnetron sputtering is manufactured and tested. This single planar solid oxide fuel cell exhibits a power density of 560 mW cm–2under a voltage of 0.7 V at 800 °C and a maximal power density of 660 mW cm–2is reached.Keywords
This publication has 15 references indexed in Scilit:
- Ohio Third Frontier fuel cell funding for 2010Fuel Cells Bulletin, 2010
- Preparation of YSZ electrolyte coatings for SOFC by electron beam physical vapor deposition combined with a sol infiltration treatmentMaterials Science and Engineering: B, 2008
- Structural investigations of YSZ coatings prepared by DC magnetron sputteringSurface and Coatings Technology, 2007
- Preparation of YSZ film by EPD and its application in SOFCsJournal of Alloys and Compounds, 2006
- Study of deposition and post-oxidation of d.c. magnetron sputtered W/Fe bilayersSurface and Coatings Technology, 2005
- Fabrication of thin electrolytes for second-generation solid oxide fuel cellsSolid State Ionics, 2000
- Thin-film solid oxide fuel cell with high performance at low-temperatureSolid State Ionics, 1997
- Pulsed magnetron sputter technologySurface and Coatings Technology, 1993
- Advances in partial-pressure control applied to reactive sputteringSurface and Coatings Technology, 1989
- Book ReviewsOccupational Medicine, 1989