Optical Fiber Strain Measurements and Numerical Modeling of Load Tests on Grouted Anchors
Authors:
- 1 December 2019
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 145 (12)
Abstract
This paper reports on the behavior of a grouted anchor instrumented with a fiber optic strain sensor in the grout body along the entire anchor length. During load tests up to the estimated pull-out capacity, the strain measurements indicate that a delamination occurs in the tendon bond length between the steel tendons and the grout body. The upper delaminated part of the grout body is under compression, whereas the lower bonded part of the grout body is under tension. This delamination gradually progresses as the anchor load increases. Furthermore, a significant part of the load is transferred from the anchor to the soil in the tendon free length. The anchor behavior is further modeled with a one-dimensional finite-element model that includes the steel tendons and the grout body, where an interface damage model is used to account for possible delamination of the interface. The numerical model confirms that the observed compressive and tensile strains in the grout can be related to a delamination of the steel strands in the tendon bond length. The experiment and numerical modeling demonstrate how optical fiber measurements in the grout body can be used, in operational conditions, to assess the anchor behavior, the mobilization of the soil resistance, and the estimation of the remaining anchor capacity.Keywords
This publication has 13 references indexed in Scilit:
- Recent progress of using Brillouin distributed fiber optic sensors for geotechnical health monitoringSensors and Actuators A: Physical, 2017
- A Review of Distributed Optical Fiber Sensors for Civil Engineering ApplicationsSensors, 2016
- Untersuchungen zur Zementfiltration während der Herstellung von Verpressankern in nichtbindigen BödenBautechnik, 2015
- Numerical modelling of the concrete/rebar bondCement and Concrete Composites, 2015
- A distributed self-sensing FRP anchor rod with built-in optical fiber sensorMeasurement, 2013
- Non‐Linear Finite Element Analysis of Solids and Structures2012
- Elastoplastic Damaging Model for Adhesive Anchor Systems. I: Theoretical Formulation and Numerical ImplementationJournal of Engineering Mechanics, 2011
- Tieback Walls in Sand: Numerical Simulation and Design ImplicationsJournal of Geotechnical and Geoenvironmental Engineering, 1999
- Back analysis procedures for the interpretation of field measurements in geomechanicsInternational Journal for Numerical and Analytical Methods in Geomechanics, 1987
- Interaction Analysis Of Anchor‐Soil SystemsJournal of Geotechnical Engineering, 1986