Effects of Manganese on the Microstructures, Mechanical Properties and Deformation Characteristics of Cu-29Zn Alloy
Authors:
- 1 March 2018
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 917, 212-217
Abstract
Deformation characteristics of brass alloy are still under discussion, particularly concerning the critical level of when the change of deformation mechanism occurs. Previous research showed that the addition of Mn on brass alloys resulted in grain refinement and mechanical properties alteration. However, the effects of Mn on the deformation characteristic of brass alloys have not been investigated. In this research, Cu-Zn-xMn alloys were manufactured by gravity casting process using pure Cu and Zn ingots, as well as Mn chips as the feeding materials. Mn addition was varied to 1.26, 3.48, and 5.83wt.%. As-cast samples were homogenized at 800 °C for 2 h in a muffle furnace. The samples were then cold-rolled with the level of deformation of 20, 40, and 70 %. Samples characterization includes chemical composition analysis, microstructure observation, tensile and hardness testing. The results showed that addition of Mn for 5.83 wt.% and above created β’ phase, which is richer in Mn compare to that in the matrix. This phase segregated in the grain and along the grain boundary with irregular forms. Significant increase in hardness, yield and tensile strengths was observed with addition of Mn. The maximum elongation was achieved by addition of 3.48 wt.% Mn, while further addition tended to decrease it. At 20% deformation, slip dominated and its density reduced with addition of Mn. When the deformation level increased to 40%, twinning replaced slip as the predominant mechanism. Twinning density is slightly increase with the presence of Mn. Further deformation at 70% produced shear bands and flattened the β’ phase. Greater Mn content led to formation of more shear band.Keywords
This publication has 12 references indexed in Scilit:
- Effects of Deformation and Annealing Temperature on the Microstructures and Hardness of Cu-29Zn-0.6Bi BrassKey Engineering Materials, 2017
- Crystallographic Texture of Materials2014
- Effect of stacking fault energy and strain rate on the mechanical properties of Cu and Cu alloysJournal of Alloys and Compounds, 2013
- Effect of stacking fault energy on deformation behavior of cryo-rolled copper and copper alloysMaterials Science and Engineering: A, 2011
- Influence of bismuth and lead on the formation of the structure of experimental alloys with a Cu-30% Zn-based composition during crystallization, deformation, and thermal treatmentRussian Journal of Non-Ferrous Metals, 2010
- Effect of silicon addition on grain refinement of copper alloysMaterials Letters, 2003
- Deformation and texture of copper–manganese alloysActa Materialia, 2000
- Deformation texture transition in brass: critical role of micro-scale shear bandsActa Materialia, 2000
- Diffusion in copper and copper alloys. Part III. Diffusion in systems involving elements of the groups IA, IIA, IIIB, IVB, VB, VIB, and VIIBJournal of Physical and Chemical Reference Data, 1975
- The dependence of rolling texture on stacking fault energyActa Metallurgica, 1964