High power active-band pulse compressor using plasma switches
Authors:
Open Access
- 30 June 2009
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review Special Topics - Accelerators and Beams
- Vol. 12 (6) , 062003
Abstract
Results obtained in several experiments on active rf pulse compression at band using a magnicon as the high-power rf source are presented. In these experiments, microwave energy is stored in high- and modes of two parallel-fed resonators, and then discharged using switches activated with rapidly fired plasma discharge tubes. Designs and high-power tests of several versions of the compressor are described. In these experiments, coherent pulse superposition was demonstrated at a 5–9 MW level of incident power. The compressed pulses observed had powers of 50–70 MW and durations of 40–70 ns. Peak power gains were measured to be in the range of with efficiency in the range of 50%–63%.
Keywords
This publication has 9 references indexed in Scilit:
- Two-channel 100-MW microwave compressor for the three-centimeter wavelength rangeRadiophysics and Quantum Electronics, 2008
- A plasma switch based on TE02 → TE01 round waveguide mode conversion for high-power X-band microwave compressorsTechnical Physics Letters, 2007
- High-power multimode-band rf pulse compression system for future linear collidersPhysical Review Special Topics - Accelerators and Beams, 2005
- Study of Active Microwave Compressors Excited by Magnicon Radiation at a Frequency of 11.4 GHzRadiophysics and Quantum Electronics, 2003
- Development of high power-band semiconductor microwave switch for pulse compression systems of future linear collidersPhysical Review Special Topics - Accelerators and Beams, 2002
- Active high-power RF pulse compression using optically switched resonant delay linesIEEE Transactions on Microwave Theory and Techniques, 1997
- Prepulse suppression in microwave pulse-compression cavitiesReview of Scientific Instruments, 1986
- Binary Peak Power Multiplier and its Application to Linear Accelerator DesignIEEE Transactions on Microwave Theory and Techniques, 1986
- Microwave energy compression using a high-intensity electron beam switchJournal of Applied Physics, 1980