The effect of silica nanoparticles obtained from different sources on mechanical properties of polyurethane nanocomposites
Open Access
- 1 January 2024
- journal article
- research article
- Published by Centre for Evaluation in Education and Science (CEON/CEES) in Engineering Today
- Vol. 3 (2) , 35-43
Abstract
Spherical silica particles were synthesized from two different sources, tetraethyl orthosilicate (TEOS) and sodium silicate obtained from wheat straw ash, respectively. In the first case, monodispersed and microporous silica particles with average particle size of 400 nm were prepared by hydrolysis and condensation of TEOS. In the second case, the silica particles were generated from supersaturated sodium silicate solution. The extraction of silicate solution from wheat straw ash (WSA) was performed by the multi-step sequential extraction using 2,5 mol/L NaOH. WSA silica particles were polydispersed and contain the primary silica particles with average size of ~250 nm and agglomerates obtained by aggregation of primary silica particles, with average size of ~1.5 mm and 5 mm. The silica particles obtained from WSA have the average pore size of 28.3 nm, total pore volume of 0.1638 cm3 /g and average surface area of 23.131 m2 /g. Flexible polyurethane/silica composites with my(TEOS silica and WSA silica) and different filler concentration were synthesized. Dispersion of silica fillers in polyol system preceded the mixing with isocyanate resulted in formation of cavities in polyurethane-silica composite. On the other hand, dispersion of TEOS silica filler into isocyanate which preceded the mixing with polyol system resulted in homogenous and compact composite. The application of silica filler obtained from TEOS at filler concentration of 4 wt.% increased Young's modulus for 20% relative to that of polyurethane without filler. On the other side, the application of WSA silica filler resulted in reduced Young' s modulus probably due to large silica aggregates.Keywords
Funding Information
- Ministry of Education, Science and Technological Development of the Republic of Serbia (451-03-68/2020-14/200088)
This publication has 13 references indexed in Scilit:
- Polyurethane foams from vegetable oil-based polyols: a reviewPolymer Bulletin, 2022
- Agricultural and industrial waste-derived mesoporous silica nanoparticles: A review on chemical synthesis routeJournal of Environmental Chemical Engineering, 2022
- Preparation of waterborne polyurethane-silica nanocomposites by a click chemistry methodMaterials Today Communications, 2020
- Physisorption of gases, with special reference to the evaluation of surface area and pore size distribution (IUPAC Technical Report)Pure and Applied Chemistry, 2015
- Synthesis of mesoporous silica particles with controlled pore structureCeramics International, 2009
- Structure and properties of polyurethane/nanosilica compositesJournal of Applied Polymer Science, 2005
- Hydrogen Bonding of Water Confined in Mesoporous Silica MCM‐41 and SBA‐15 Studied by 1H Solid‐State NMRChemistry – A European Journal, 2004
- The study of formation colloidal silica via sodium silicateMaterials Science and Engineering: B, 2004
- Biomass burning in Asia: Annual and seasonal estimates and atmospheric emissionsGlobal Biogeochemical Cycles, 2003
- Controlled growth of monodisperse silica spheres in the micron size rangeJournal of Colloid and Interface Science, 1968