Microwave measurements in cured concrete — Experiment and modelling
- 1 February 2018
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 67-68
Abstract
Cured concrete is a low-loss insulating material. A copper rod placed in a concrete beam (350 × 100 × 100 mm 3 ) was exposed to microwave radiation (1-5 GHz) from a slot antenna optimised for impedance matching to the concrete surface. The copper rod enhanced the power inside the concrete samples. Surface measurements of the scattered electric field show a series of interference nulls reaching amplitude of -30 dB. This paper reports experimental measurements and modeling results of the surface electric field. Particle swarm optimization was used to match the modelled to the experimental E-field by varying the relative permittivity and electric conductivity. The technique was used to determine the electromagnetic properties of cured concrete in the frequency range 1-5 GHz.Keywords
This publication has 6 references indexed in Scilit:
- Surface Field Measurements From a Buried UHF Transmitter: Theory, Modeling and Experimental ResultsIEEE Transactions on Antennas and Propagation, 2017
- Application of Jonscher model for the characterization of the dielectric permittivity of concreteJournal of Physics D: Applied Physics, 2008
- Field monitoring of electrical conductivity of cover-zone concreteCement and Concrete Composites, 2005
- Condition monitoring of deteriorating concrete dams using radarCement and Concrete Research, 2001
- Electrical conductivity of concrete containing silica fumeCement and Concrete Research, 1995
- Simple expressions for horizontal electric dipole quasi‐static range subsurface‐to‐subsurface and subsurface‐to‐air propagationRadio Science, 1978