Inorganic Cement Grouting for Reinforcing Triangular Zone of Highly Gassy Coal Face with Large Mining Height
Open Access
- 25 September 2018
- Vol. 11 (10) , 2549
Abstract
Aiming to address the serious problem of coal wall spalling in the triangular zone of the coal face end under high-intensity mining, this paper introduces inorganic cement grouting reinforcement technology for medium-depth holes based on the specific geological conditions of the Sihe coal mine in China. Firstly, the effects of different water-to-material ratios and various accelerators on setting time and uniaxial compressive strength (UCS) of grouting materials and consolidation coal are studied. The results show that the combination of 2% accelerator I, 0.3% accelerator II, and 3.0% accelerator III was the most effective. Then, FLAC3D numerical simulation software was used to analyze the distribution laws of the plastic zone, the lateral abutment pressure, and abutment stresses in the face ends during repeated mining. The results indicate that the zone within 25–65 m of the front of the coal face was initially affected by the front abutment pressure. In this area, the stress value decreased slowly and fracture development was relatively intense. Grouting with high pressure and a large flow rate should be used in this scenario as the industrial experiment results indicated that the proposed inorganic cement grouting reinforcement technology could effectively control coal wall spalling and provide technical support for safe and efficient mining.Keywords
Funding Information
- Dongsheng Zhang (2015CB251600)
- dongsheng zhang (BK20150051)
- Gangwei Fan (51504240)
- Dongshegn Zhang (Grant Sujiaoshi (2016)15)
This publication has 18 references indexed in Scilit:
- Reinforcement selection for deep and high-stress tunnels at preliminary design stages using ground demand and support capacity approachInternational Journal of Mining Science and Technology, 2018
- Laboratory testing of a long expansion rock bolt support for energy-absorbing applicationsE3S Web of Conferences, 2018
- Mechanism and Prevention of a Chock Support Failure in the Longwall Top-Coal Caving Faces: A Case Study in Datong Coalfield, ChinaEnergies, 2018
- Failure of bolt support and experimental study on the parameters of bolt-grouting for supporting the roadways in deep coal seamEngineering Failure Analysis, 2017
- Determination of the Height of the Water-Conducting Fractured Zone in Difficult Geological Structures: A Case Study in Zhao Gu No. 1 Coal SeamSustainability, 2017
- Structural characteristics of key strata and strata behaviour of a fully mechanized longwall face with 7.0m height chocksInternational Journal of Rock Mechanics and Mining Sciences, 2013
- New development of sets equipment technologies for coal mine long-wall face in ChinaJournal of Coal Science and Engineering (China), 2012
- A numerical investigation of rock pillar failure mechanism in underground openingsComputers and Geotechnics, 2009
- Effect of grout pressure and grout flow on soil physical and mechanical properties in jet grouting operationsInternational Journal of Rock Mechanics and Mining Sciences, 2009
- Grouting applications in the Istanbul metro, TurkeyTunnelling and Underground Space Technology, 2006