Results of Inspections in Health Hazard Industries in a Region of the State of Washington
- 25 April 2008
- journal article
- research article
- Published by Taylor & Francis in Journal of Occupational and Environmental Hygiene
- Vol. 5 (6) , 367-379
Abstract
Results from state of Washington Occupational Safety and Health Administration (OSHA) health inspections were reviewed to characterize the level of control that existed at the work sites, identify common problems, and assess the success of targeting programs in finding and correcting uncontrolled health hazards. Data were obtained from 170 inspections conducted by industrial hygienists in a four-county area in 12 industries, including 10 that were targeted. Inspection data were accessed through the use of electronic databases and inspection reports then summarized by the following industries: bathtub refinishing, carbide tool and saw sharpening, fibercement siding installation, furniture refinishing, health care clinics, janitorial floor waxing service, landscaping, lawn maintenance, tree service, road construction, stone countertop fabrication, truck bed lining, warehouse and cold storage, and wood floor finishing. Targeted health hazards included worker exposure to airborne contaminants, noise, and bloodborne pathogens typical of the industry. Method and effectiveness of control of health hazards were evaluated by counting work sites with violations associated with engineering control, personal protective equipment, hearing conservation, or training. Results are presented by industry for the number and percentage of work sites that failed to provide required protection. Poor control of health hazards was generally found across all inspected industries. Follow-up inspections and self-reports of abatement found that more than 85% were able to successfully control the hazards and abate the violations. The results are further discussed as they relate to methods of control and risk and identifying existing and emerging high health hazard industries. Based on employment data and the poor hazard control that was found, most if not all the industries can be described as high health hazard, small-employer industries. The results can be used for the planning of interventions in other regions and industries.Keywords
This publication has 41 references indexed in Scilit:
- Development and pilot test of hearing conservation training for construction workersAmerican Journal of Industrial Medicine, 2007
- Noise exposure and hearing loss prevention programmes after 20 years of regulations in the United StatesOccupational and Environmental Medicine, 2006
- OSHA Compliance IssuesJournal of Occupational and Environmental Hygiene, 2004
- Occupational Carbon Monoxide Poisoning in the State of Washington, 1994-1999Applied Occupational and Environmental Hygiene, 2002
- Silica Exposure During Granite Countertop FabricationApplied Occupational and Environmental Hygiene, 1999
- Industrial Hygiene Recommendations as Interventions: A Collaborative Model Within Occupational MedicineApplied Occupational and Environmental Hygiene, 1999
- OSHA Compliance Issues: Targeting Industries and Work Sites for OSHA Health InspectionsApplied Occupational and Environmental Hygiene, 1996
- Silicosis surveillance in New Jersey: Targeting workplaces using occupational disease and exposure surveillance dataAmerican Journal of Industrial Medicine, 1992
- Current Magnitude of Occupational Disease in the United StatesAnnals of the New York Academy of Sciences, 1989
- Respirator cartridge efficiency studies: VIII. summary and conclusionsAIHA Journal, 1976