Characteristic analysis and design of a B14 rotary ultrasonic motor for a robot arm taking the contact mechanism into consideration
Authors:
- 16 April 2007
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 54 (4) , 715-728
Abstract
The ultrasonic motor (USM) has many merits for use in a robot arm application. Therefore, the disk-type traveling wave B 14 rotary ultrasonic motor (RUSM) is proposed in this paper for that application. Up to the present time, the analysis and design of the USM have been almost always performed using rough analytic methods or using commercial analysis tools. As a result, it was impossible to achieve an exact analysis and design of the USM. In order to address this problem, this paper proposes the analysis and design methodology of the B 14 RUSM using a numerical method (3-D FEM) combined with an analytic method taking the contact mechanism into consideration in a linear operation. This methodology is applicable to many other kinds of USMs that use similar mechanisms. In addition, the mechanical system and the driving circuit of the B 14 RUSM are designed and prototyped. Finally, the proposed analysis and design methodology is validated by comparing its outcomes with the experimental data. Also, the appropriateness of the suggested RUSM for the application of a robot arm was verifiedKeywords
This publication has 17 references indexed in Scilit:
- Design and characteristic analysis of L1B4 ultrasonic motor considering contact mechanismIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2005
- Industrial design of a centimetric “TWILA” ultrasonic motorSensors and Actuators A: Physical, 2005
- Finite element analysis of piezoelectric transducers2003
- A small size ultrasonic motor2002
- Novel method for driving the ultrasonic motorIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2002
- New schemes for the finite-element dynamic analysis of piezoelectric devicesJournal of Applied Mathematics and Mechanics, 2002
- Performances estimation of a rotary traveling wave ultrasonic motor based on two-dimension analytical modelUltrasonics, 2001
- Same phase drive-type ultrasonic motors using two degenerate bending vibration modes of a diskIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1992
- An estimation of load characteristics of an ultrasonic motor by measuring transient responsesIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1991
- Simulation of piezoelectric devices by two- and three-dimensional finite elementsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1990