Minimizing Entropy Generation in Heat Exchanger Tubes With Ball Inserts: Numerical Simulation
Author:
- 19 February 2026
- journal article
- Published by Wiley in Heat Transfer
- Vol. 55 (4) , 2544-2556
Abstract
This study analyzed entropy generation (EG) in a heat exchanger tube with ball inserts, with a constant heat flux boundary condition. The effects of ball diameter (4−6 mm) and ball pitch (15−25 mm) on EG were analyzed within the Reynolds number range Re = 6000−18,000. Furthermore, a mathematical model of EG was developed, and analyses were performed using a numerical simulation approach. The results indicate that EG decreases as the ball diameter increases, the ball pitch decreases, and the Reynolds number increases. Therefore, the smallest ball pitch and the largest ball diameter result in low EG. In this configuration, the Nusselt number and friction factor increase by 1.48−1.74 and 2.99−3.55 times, respectively, compared with a smooth tube, and the maximum thermohydraulic performance reaches 1.2 at the minimum Reynolds number. The maximum deviation between the predicted value of EG and the simulation data is 8%. Overall, the configuration with the largest ball diameter and smallest ball pitch yields the lowest EG, an enhanced heat transfer rate, and a potential solution to the group of solutions for enhancing heat transfer in heat exchanger tubes.Keywords
This publication has 35 references indexed in Scilit:
- Experimental analysis of heat exchanger using perforated conical rings, twisted tape inserts and CuO/H2O nanofluidsCase Studies in Thermal Engineering, 2023
- Experimental study on the thermophysical properties, heat transfer, thermal entropy generation and exergy efficiency of turbulent flow of ZrO2-water nanofluidsAlexandria Engineering Journal, 2022
- Effect of dimple pitch on thermal-hydraulic performance of tubes enhanced with ellipsoidal and teardrop dimplesCase Studies in Thermal Engineering, 2022
- Flow Field Structure, Characteristics of Thermo-Hydraulic and Heat Transfer Performance Analysis in a Three Dimensions Circular Tube with Different Ball Turbulators ConfigurationsArabian Journal for Science and Engineering, 2021
- Entropy generation of nanomaterial through a tube considering swirl flow toolsJournal of Thermal Analysis and Calorimetry, 2020
- A review of heat transfer and fluid flow mechanism in heat exchanger tube with insertsChemical Engineering and Processing - Process Intensification, 2018
- Influences of corrugation profiles on entropy generation, heat transfer, pressure drop, and performance in a wavy channelApplied Thermal Engineering, 2017
- Tube-in-tube helical heat exchangers performance optimization by entropy generation minimization approachApplied Thermal Engineering, 2016
- Geometric optimization for thermal–hydraulic performance of dimpled enhanced tubes for single phase flowApplied Thermal Engineering, 2016
- Application of rough surfaces to heat exchanger designInternational Journal of Heat and Mass Transfer, 1972